Electrolux EFC 6405 Service Instructie - Pagina 10

Blader online of download pdf Service Instructie voor {categorie_naam} Electrolux EFC 6405. Electrolux EFC 6405 19 pagina's. Aes ii absorption refrigerators
Ook voor Electrolux EFC 6405: Gebruikershandleiding (13 pagina's), Gebruikershandleiding (12 pagina's), Gebruikershandleiding (16 pagina's), Servicehandleiding (19 pagina's), Gebruikershandleiding (12 pagina's)

Pagina afdrukken

Cause 3:

After the lifting magnet drops, the AES again tries to ignite and then goes to a

fault after 25 seconds. Is the thermoelement on the thermocurrent adapter

loose?

Elimination 3:

Hand-tighten the screw connection (SW 8mm).

Cause 4:

The thermoelectric voltage is not sufficient to keep the ignition fuse open. The

reason is due to wear and tear and component tolerances, for example:

1. Bad thermoelement (soot formation)

2. The thermocurrent adapter's internal resistance is too high.

3. The holding current for the magnetic insert for the ignition fuse is too much.

Elimination 4:

Exchange the thermocurrent adapter and the ignition fuse and/or

thermoelement. (See Bulletin 599 4721-91/7, Page 16.)

Cause 5:

The lifting magnet does not press the ignition fuse down deeply enough, so

there is no mechanical contact in the magnetic insert

Elimination 5:

To check after tightening the lifting magnet, press down on the red ignition fuse

button. If the flame stops after the lifting magnet drops, the lifting magnet or the

ignition fuse must be adjusted.

2. Interior Light

In the factory setting, the AESII electronics control the lighting. If there is a lighting defect, first

check the light. If the lighting does not function even if the light is intact, you must proceed as fol-

lows:

1. Disconnect and insulate the white

and yellow cable on the connec -

ting terminal (A).

2. Connect the B and C connections

of the connecting terminal together

to test them.

If the lighting functions, use a

15-Ohm resistor with

spare part number 295 1749-10/6 in

the connecting terminal as a

connection.

Terminal block

AES II

ELECTRONIC

black

brown

white

12V-connection

Ground

black

Ground