Electrolux EFC 6940 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Electrolux EFC 6940. Electrolux EFC 6940 13 pagina's. Electrolux cooker hood
Ook voor Electrolux EFC 6940: Gebruikershandleiding (16 pagina's), Gebruikershandleiding (16 pagina's), Gebruikershandleiding (16 pagina's)
Pagina afdrukken
Control Panel
• The hood is fitted with one motor having several speed. Turn the hood on a few minutes before you start
cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for
about 15 minutes or until all the odours have disappeared.
The control switches are located on the unit's front panel:
• The hood operation may be controlled via the control ball or with the remote control (the remote control is a
special accessory and is ordered separately).
Every status change (changing speed, switching on the lights, etc.) and is recognizable from the variation of
light emitted by the control ball and by an acoustic signal.
The control ball serves also as a light signal :
• No signal :
The hood is switched off.
• Static green light :
Hood is switched on at power level 1
(minimum).
• Static orange light :
Hood is switched on at power level 2 (medium).
• Static red light :
Hood is switched on at power level 3
(maximum).
• Alternating red light :
Hood is switched on at intensive power level
(timed at 5 minutes)
• Alternating green light :
Indicates the grease filter saturation - clean the
grease filter
• Alternating orange light :
Indicates the charcoal filter saturation - clean
or replace the charcoal filter
Attention!
The control Ball flashes orange to indicate the
saturation of the odor filter even when the
charcoal filter is not installed inside the cooker
hood.
However perform the signal reset operation as
follows: select the intensive speed (the control
ball lights up with a red flashing light), depress
again and hold depressed for about 3 seconds
until a 'bip' sound indicates the reset.
Switching on the hood - Fig. 3
The control ball is a balancer switch.
Depressing the control ball repeatedly towards the
right switches on the hood and you may select the
suction level desired, depressing once again on the
right the hood switches off.
Switching on the light - Fig. 3
Depress the control ball towards the left :
once for submersed lighting,
once again for full lighting,
depress again to switch off the light.
depress towards
the right to switch
on the hood
Control device for grease or
charcoal filter
The air duct, in this hood, is provided with a device
that signals when the filter requires cleaning or
changing .
Led signal for grease filter
The LED signal flickers (flickering green light)
when the grease filter requires cleaning, occurs at
about 40 operating hours.
Carefully note the device for grease filter
maintenance!
Led signal for charcoal filter
The LED signal flickers (flickering orange light)
when the grease filter requires cleaning, occurs at
about 160 operating hours.
Carefully note the device for charcoal filter
maintenance!
Resetting the saturation
indicator
After cleaning or replacing the filter, select the
intensive speed (the control ball lights up with a red
flashing light), depress again and hold depressed
for about 3 seconds until a 'bip' sound indicates the
reset.
Correct ventilation
If the cooker hood is to work correctly there must
be an under pressure in the kitchen. It is important
to keep the kitchen windows closed and have a
window in an adjacent room open
32
depress towards
the left to switch
on the light.
Fig. 3