Andrew LeBlanc Zero Gravity Chairs Gebruiks- en onderhoudshandleiding - Pagina 2
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Andrew LeBlanc Zero Gravity Chairs. Andrew LeBlanc Zero Gravity Chairs 3 pagina's.
Pagina afdrukken
UNPACKING YOUR CHAIR
Please be careful opening the
box. Do not use a box cutter. A
deep cut could penetrate the
inner box liner and damage your
chair. Open the box and remove
protective cardboard insert.
Remove backrest then lift the
protective cardboard insert to
one side. With two people, one
on each side carefully lift and
remove the base chair assembly
from the box.
Remove plastic bags covering the
base and backrest.
BACKREST INSTALLATION
Four ¾" flat head screws and an
Allen wrench are packaged in a
small plastic bag and secured with
an elastic to one of the lower
backrest mounting plates.
The backrest is installed by standing
behind the chair base and firmly
sliding the backrest assembly down
into the left and right mounting
brackets that are at the back of the
seat cushion.
Line the holes in the backrest with
the holes in the brackets and install
the flathead screws with the Allen
wrench. When installing the screws
be careful that they are properly
aligned with the nuts in the
backrest frame.
INSTALLING THE
LUMBAR SUPPORT
Open the lumbar support pocket at
the base of the backrest. Insert the
lumbar air bladder into the pocket
with the inflation tube on the right
side (sitting in the chair). You can
position the lumbar air bladder left,
right, up and down to satisfy your
personal requirements. Once the air
bladder is positioned tuck the
lumbar pocket flap in between the
seat cushion and backrest. To
increase support, pump the bulb, to
decrease support depress the button
on the side of the inflation bulb and
gently push against the air bladder.
THE CERVICAL PILLOW
The cervical pillow is positioned
with a blind zipper on the back of
the chair. Adjust the pillow to the
top of the backrest before sitting.
Once you are comfortably seated
pull the cervical pillow down to a
position that gently supports your
neck and upper spine.
Your cervical pillow has maximum
dacron cushioning when it leaves
the factory. If you find the pillow is
too full easily adjust it by undoing
the zipper on the back of the
headrest, lift the zipper cloth baffle
panel and remove dacron until the
pillow is at the desired fullness.
Put the cloth baffle panel back and
zip closed.
ARTICULATING HEADREST
The headrest is positioned with a
friction hinge that allows it to tilt
forward 15 degrees.
To adjust the headrest angle, sit in
the chair, raise your arms over your
head, reach back and grab the top of
the backrest, hold the upper backrest
in position, with your shoulders pull
the top of the headrest forward.
To return push back.