Atlantic ColorFalls CC06 Bedieningshandleiding - Pagina 3

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Atlantic ColorFalls CC06. Atlantic ColorFalls CC06 14 pagina's. Color changing colorfalls
Ook voor Atlantic ColorFalls CC06: Bedieningshandleiding (14 pagina's)

Pagina afdrukken

Plumbing Modular Colorfalls

Connect the Colorfalls together using 1½" Schedule 40 PVC Pipe. The pipe stub

should be 1

" long, which will ensure that the weirs touch when glued together.

When gluing multiple Colorfalls together, make sure that it is done on a flat

surface, so the lips of the weirs line up perfectly (Figure 2). Secure the Colorfalls

together until the glue has set.

1½" Sch 40 pipe (1

Figure 2

Clean and Glue

When plumbing multiple Color Changing Colorfalls together, use the back center

inlet on each individual Colorfalls, plugging the side inlets, regardless if you are

using one pump or multiple pumps. This will balance the flow of water going to

the falls. The individ-

ual feed lines to each

Colorfalls should be

1½" PVC. If using one

pump to feed multiple

Colorfalls, the main

feed line should be

2" or larger. The main

feed line should be run

horizontally along the

back of the wall with

vertical 1½" feed lines

branching off to each

Colorfalls (Figure 3).

Figure 3

Operation

Technical Data (Control Module)

Working Temperature:

0ºF -140ºF (-20°C - 60ºC)

Output: 3 circuits (R/G/B)

" long)

1½"

2" Feed

Input Power: AC12V

Output Power: DC12V, <144W

Output Current: <4A /circuit

Installation Requirements

1. The Control Module is weather resistant with an IP54 rating. Do not submerse it

or expose it to heavy rainfall. It must be mounted off the ground close to the

power source. Failure to do so will void the warranty.

2. Ensure that all cable connections are secure.

3. Install the control box in a well ventilated area to ensure that the module

operates in within its working temperature specified above.

4. Verify that the control module input voltage is 12 volt AC. We recommend that

you use the transformer provided with this unit.

5. Do not connect the power before the cord connections are finished.

6. Do not cut or alter the cord between the Colorfalls and the Control Module.

7. The remote control requires three (3) AAA batteries (not included).

Connecting the Light Bar

Follow the connecting chart below to connect all cables. Ensure that the

unit is not plugged in while connecting.

LED Light Strip

Atlantic's CCCM05 Master Controller (sold separately) enables up to five individual

Color Changing light bars to be synchronized to change colors at the same time

using one remote. In this application, only one Control Module and one remote

are required. Use a Control Module and remote from any Colorfalls and it will

control all light bars when used with the CCCM05 Master Controller. Replace the

transformer from your Colorfalls with the 80 watt transformer from the Master

Controller, and connect the 5-Way splitter supplied with the CCCM05 between the

Control Module and the light bars. See the connecting chart below for details.

Lines

Control Module

LED Light Strip

Control Module

5-Way Splitter

Transformer