Atlantic Blowers AB-1000 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Atlantic Blowers AB-1000. Atlantic Blowers AB-1000 17 pagina's.

1-3 Plumbing

Remove any foreign material (burrs, chips, welding drops, slag, pipe cuttings, excess sealant, sand, lime, etc.) from plumbing.

Verify the motor is securely mounted and has proper impeller rotation before connecting to plumbing. The inlet and outlet ports are

not designed to support the plumbing without proper structural reinforcement. Remove plastic safety plugs from the inlet and outlet

ports and connect the plumbing with properly sized fittings.

Use a relief valve to discharge excess air beyond the preset level on pressure applications. Use a vacuum relief valve to draw in

excess air when preset vacuum level is achieved. This will greatly reduce the possibility of over-heating.

Install an intake filter to prevent foreign material from entering the blower. In applications where there is high humidity or liquids

being used in the process, install a moisture separator with a drain valve.

1-4 Accessories

Install a filter monitor gauge to monitor the pressure/vacuum differential through the filter element. As filters become clogged,

performance and efficiency will be reduced. Filters should be checked periodically and replaced when necessary. The

recommended check valves provide minimal pressure drop, positive sealing, and are resistant to the high discharge

temperatures of the blowers. (Refer to Atlantic Regenerative Blower Check Valves List)

1-5 Motor Control

It is your responsibility to contact a qualified electrician and ensure that the electrical installation is adequate and in compliance

with all national and local electrical codes.

Select fuses, motor protective switches, or thermal protective switches to provide desired protection. Fuses act as short

circuit protectors for the motor, not as protection against overloading. Incoming line fuses must be able to withstand the

motor´s starting current. Motor starters with thermal magnetic overload or circuit breakers protect motor from overload or

reduced voltage conditions. Motors without automatic restart require thermal protection, magnetic or over -current cutout to

prevent motor overloading from single phasing in a 3-phase circuit, high starting frequency, or locked blower.

Failure to follow these instructions can result in death, fire or electrical shock.

x Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified/certified electrician.

x If repairing the cord or plug, do not connect the ground wire (green or green with yellow stripes) to either terminal.

x Check the condition of the power supply wires.

x Do not permanently connect this product to wiring that is in poor condition or that is inadequately sized for the requirements of

this blower.