Atlantic Technology System T90 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Atlantic Technology System T90. Atlantic Technology System T90 8 pagina's. High performance compact home theater loudspeaker system

Pagina afdrukken

Warning: To prevent risk of electrical shock or damage to your equipment, always switch off the amplifier or

receiver when making connections to the speakers.

You can connect your T90 speakers by using a variety of audio connectors such as pin connectors,

spade lugs, etc., or you can:

1. Remove 1/2" of insulation from each wire end.

2. Twist the stranded wire together, keeping the two conductors separate.

3. Place the appropriate conductor through the appropriate postholes in the connectors. These holes are

revealed when you loosen the connector capscrew.

4. Screw down the capscrew tightly, but be careful not to over tighten. Check the tightness of the

capscrews 24 hours after hookup and occasionally thereafter, as they can loosen over time.

We recommend that you check your local electrical codes to make sure that you are not using an

improper connector.

Figure 1:

Gold plated 5-way

binding posts.

Accepts up to 10

gauge bare wire

When you're done hooking up your T90 system the wiring should look like the diagram in Figure 2.

WARNING: Before turning on the amplifier, be certain that no stray wire strands are touching across any

terminals, as this might damage your amplifier.

After all the connections are made check the polarity of your front speakers by listening to stereo

music. If the sound seems hollow, unusually spread out, or has weak bass, recheck your connections

for proper polarity and reverse any out of phase connections, if necessary. Usually one speaker wired

out of phase is the culprit.

Placement and Operation

Speaker/room interactions have a huge impact on the sound of the system. Moving the speakers just a

little bit can make a dramatic difference in what you hear. The compact design of T90 provides

maximum placement flexibility, while creating a large, seamless, acoustically accurate soundfield for

your system. The best placement of the speakers will vary from room to room. Use the following

placement guidelines and Figure 3 as a starting point. But also feel free to experiment. In fact, it may

be beneficial to hook up the speakers with some extra wire and to simply drape the wire across the

floor before installing the speakers permanently. This will allow you the opportunity to move the

speakers around easily so you can find the best sonic and visual locations.

Home Theater Placement

Our philosophy is simple. We believe the primary goal of a surround sound system isn't to make you

think you're in a movie theater. It's to make you believe you're in the movie or at the concert. So for

It's important to observe polarity while making speaker connections: red (+)

terminals on the amplifier to red (+) on the speaker, black (-) on the amplifier

to black (-) on the speaker. Look carefully at the wires you are using and note

that one of conductors of each pair will be identified by color, printing on the

outer jacket, ridges on the outer jacket, or a thread intertwined with the wire

strands. By convention, the marked wire is connected to the red (+) terminal.

Atlantic Technology