Atlantic Ultraviolet Bio-Logic BIO 1.5 Installatie, bediening en onderhoud - Pagina 10

Blader online of download pdf Installatie, bediening en onderhoud voor {categorie_naam} Atlantic Ultraviolet Bio-Logic BIO 1.5. Atlantic Ultraviolet Bio-Logic BIO 1.5 16 pagina's. Germicidal ultraviolet water purifiers

Pagina afdrukken

Lamp Installation or Replacement BIO-1.5 and BIO-3.0 using ballast no.10-

0518A 120v 50/60Hz and using ballast no.10-0514A 230v 50/60Hz

Figure 4 – Lamp Replacement for BIO-1.5

and BIO-3.0 (ballast no 10-0518A or 10-0514A)

Step 2 - Remove End-Cap

Remove EASY-OFF

Pull lamp cord and carefully withdraw lamp approximately 2 inches from chamber. While holding lamp

end, remove lamp socket from exposed lamp end.

4. Carefully withdraw lamp from chamber. Be sure to withdraw lamp straight out without angling

until completely clear of quartz sleeve.

Lamp and quartz sleeve are easily damaged. Exercise care when handling.

5. Reinstall lamp in reverse order.

Germicidal ultraviolet rays are harmful to eyes and skin. Do not restore power to water purifier until

lamp and both EASY-OFF

IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY

EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES.

Disconnect power to water purifier, and remove ground connector from the chamber.

End Cap by pulling cap off static gland nut.

End Caps have been properly reinstalled.

Step 3 - Remove Socket

Step 1 - Disconnect Power to Water

Purifier and Remove Ground Connector

Step 4 - Remove Lamp