Bose 301 Series III Servicehandleiding - Pagina 4

Blader online of download pdf Servicehandleiding voor {categorie_naam} Bose 301 Series III. Bose 301 Series III 13 pagina's. Direct/reflecting
Ook voor Bose 301 Series III: Gebruikershandleiding (10 pagina's)

Pagina afdrukken

Schematic Diagram

FIGURE 2

5. Woofer Phase Test

NOTE: Supply voltage should only be momentarily applied to the speaker input terminals to

avoid possible damage to the speaker.

A. Set a DC power supply to 8 volts. To ensure that the woofer is connected in phase,

connect the positive lead of the supply to the positive (+) speaker input terminal and the

negative lead to the negative (-) input terminal. The woofer should move outwards with the

application of the supply voltage.This ensures that the woofer and speaker input terminals

are wired in phase. See Schematic Diagram, Figure 2.

6. Tweeter Phase Test

A. Remove 4 screws and lift the woofer carefully away from the speaker cabinet in order to

access the terminal cup. Check the wiring on the terminal cup and on both sets of tweeter

terminals against the schematic in Figure 2. This ensures that both tweeters are wired in

phase.

REMOVING THE GRILLE ASSEMBLY

A. The grille assembly is held in place by 6 grille fasteners. To remove, CAREFULLY pull

the assembly away from the speaker (it should lift away easily).

REPAIR PROCEDURES

1. Replacing the Woofer

A. Remove the 4 screws holding the woofer in place. (Refer to Figure 3 for an exploded

view of the speaker assembly). Lift the woofer out and cut the wires connected to the

woofer terminals as close to the terminals as possible. Strip the wires and connect to the

replacement woofer. Make sure that the yellow wire is connected to the positive (+) terminal

and the green wire is connected to the negative (-) terminal of the woofer. Remount the

woofer to the cabinet using the 4 screws. Repeat the woofer test procedure.