Bose 901 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Bose 901. Bose 901 23 pagina's. Vi direct/reflecting speaker system
Ook voor Bose 901: Gebruikershandleiding (41 pagina's), Montage- en assemblage-instructies (1 pagina's), Gebruikershandleiding (12 pagina's), Installatie- en bedieningshandleiding (15 pagina's), Gebruikershandleiding (20 pagina's)

Pagina afdrukken

Figure 3

Mounting guidelines

AM195438_03_V.pdf

Hardware needed for ceiling suspension

• Screw hooks support the chains at the ceiling. They must have at least a #10 wood

thread with a shank diameter of at least

to go through any plasterboard and still have at least one inch (25 mm) of thread left to

penetrate a wood beam. For a masonry ceiling: use only high-quality metal expansion

masonry anchors that fit the thread of the ceiling hooks.

• Chain: diameter should be at least

• Screw eyes with S hooks attach chains to the speaker and must have at least a #10

wood thread with a shank diameter of at least

• All hardware (screw hooks, chain, screw eyes, S hooks) must have a manufacturer's

safe-load rating of 40 lb (18 kg) or more.

General notes on ceiling suspension

• Suspend the speakers 18 – 36 inches (45 – 91 cm) from the ceiling; do not mount them

flush to the ceiling.

• To ensure an accurate stereo image, the distance from the floor should be three to ten

feet (1 – 3.5 m). Be sure the speakers are no less than 18 inches (45 cm) from the floor.

Do not suspend the speakers exactly halfway between the floor and ceiling.

Note: If the speakers are more than 10 feet (3 m) from the floor, we suggest you lengthen

the chain supporting the rear of the speaker. By doing this you will allow the rear of the

speaker, housing eight of the nine drivers, to be angled slightly downward.

Step by step procedure for ceiling suspension

1. Ceiling: Anchor at least two screw hooks into a rigid structural ceiling support (beam,

joist, or masonry anchor). Drill pilot holes into wood using a

necessary.

2. Speaker: Use the three pre-drilled pilot holes (see Figure 2 - hole set B) on the bottom of

each speaker. Use a

⁄

inch drill bit (3.7 mm) to enlarge the pilot holes to accept the #10

thread screw eyes. Drill to a depth of

completely through the cabinet.

Note: Contact Bose

for more information on suspending speakers. See the inside back

cover for phone numbers. For details on your specific ceiling construction, consult a

qualified building contractor or professional installer.

18 – 36" (45 – 91 cm)

4 – 12'

(1.2 – 3.6 m)

8 – 18"

4 – 12'

(1.2 – 3.6 m)

18 – 36" (45 – 91 cm)

⁄

inch (4.5 mm). They should be long enough

⁄

inch (0.135 in. or 4 mm).

⁄

inch (4.5 mm) or larger.

⁄

inch (12 mm) in the speaker cabinet. Do not drill

18 – 48"

(45 – 120 cm)

–

(20 – 45 cm)

18 – 48"

(45 – 120 cm)

November 21, 2001

Setting Up

⁄

inch drill bit (3.7 mm), if