Bose Acoustimass 10 Series I Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Bose Acoustimass 10 Series I. Bose Acoustimass 10 Series I 18 pagina's. Series 2
Ook voor Bose Acoustimass 10 Series I: Gebruikershandleiding (25 pagina's), Gebruikershandleiding (17 pagina's), Handmatig (17 pagina's)
Pagina afdrukken
For realistic home theater sound
Each speaker produces only the sound directed to it by the steering logic in your surround
sound receiver. During a surround sound program the front and center speakers will emit
sound almost constantly, while the surround speakers may be silent for periods of time.
How to set your Pro-Logic receiver
You must set the volume levels for the front, center, and surround speakers at your receiver.
For use in video applications, be sure the SURROUND SOUND center mode setting of your
receiver is on NORMAL (Figure 10). The center channel and surround (rear) speakers have a
wider response range and therefore play at a slightly lower volume. The signal levels for
these speakers may need to be increased. You can adjust these levels at the receiver or
with the remote control. Your receiver may have a test tone to help you set volume levels.
If it does, follow these steps:
•
Press test tone ON at the remote.
•
Set the volume for the speakers in the following order: Left, Center, Right, Surround.
•
Balance the pink noise tone for evenness among all individual speakers.
Instructions for this process vary, depending on the brand and model of receiver you are
using. Follow your receiver owner's guide for testing and adjusting the balance of each
speaker.
Bass and treble adjustments
Upholstered furniture, wall-to-wall carpets, or heavy drapes can muffle treble (high notes),
making your speaker system sound bass heavy. Bare floors and walls and hard surface
furniture can make your speaker system sound too shrill. After listening to your speakers,
you may want to adjust the balance of bass and treble. You can use the bass and treble
controls on your receiver.
Set your Dolby AC-3 receiver correctly
Your Acoustimass-10 speakers are compatible with the output from Dolby AC-3 receivers.
Take special care to set the channel output according to the specifications listed in the chart
below. The cube speakers are full-range loudspeakers and must be set up as LARGE
speakers on the AC-3 screen menu. An exception is the center speaker, which must be set
as SMALL. Turn the subwoofer OFF. Finally, turn the LFE (low frequency effects) ON and set
the crossover frequency to 200Hz.
Speaker
Left and Right Front .......................... Large
Center ............................................... Small
Left and Right Surround ................... Large
Subwoofer ........................................ OFF (not used)
LFE (low frequency effects) .............. ON
Crossover frequency ........................ 200Hz
AM183644_01_V.pdf
Using Your Acoustimass
14 15 16 17
13
18
12
19
11
10
20
21
9
22
8
7
23
24
6
5
25
26
4
3
27
2
28
1
29
0
30
Setting at receiver
December 20, 2001
®
-10 Speakers
Figure 10
A Dolby Pro-Logic receiver set
for NORMAL surround sound
11