Atlas Copco PHE 26 Instructies voor reparatie - Pagina 6
Blader online of download pdf Instructies voor reparatie voor {categorie_naam} Atlas Copco PHE 26. Atlas Copco PHE 26 8 pagina's.
Pagina afdrukkenAssembly
1
Pre-assembling
Pre-assemble the reduction gear shaft (1),
the reduction
the reduction gear wheel (2), the bearing
gear shaft
cover (3), and the ball bearing (4).
2
Press the pre-assembled components
into the bearing end plate (7). Fasten it
with additionally secured screws (Omnifit).
3
Measure the center distance of the sun
wheel (6). If necessary, correct the dis-
tance with washers.
4
Press on the sun wheel (6) with aid of the
repair tool set (8) (service tool).
5
Fit the complete armature to the bearing
end plate (7). Mind the right position.
6
Insert the O-ring (5) into the bearing end
plate (7).
Set the center distance with aid of the
sleeve (8) (repair tool set; special tool)
to 60,5 - 0,05 mm. Check the distance
between the upper and the lower part
with aid of a feeler gauge and set the
tolerance to - 0,05 mm with washers.
Repair Instructions No.163.01/96
PHE 20 / PHE 26 / PHE 200
1
8
6
- 0,05
60.5
8
8
2
3
4
5
6
7
7
PAGE
5
1