Advanced Radiant Systems COOL-SPACE CS6-36 Bedienings- en onderhoudshandleiding - Pagina 13

Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} Advanced Radiant Systems COOL-SPACE CS6-36. Advanced Radiant Systems COOL-SPACE CS6-36 16 pagina's.

Pagina afdrukken
6.2 Repair procedures (continued)
BLIZZARD (CS5-48) Belt Drive Models
1. Remove the motor wiring plate and disconnect motor wires. Mark each wire with a
marker that will allow easy matching when new motor is installed. (see section 5.1 for
pad removal instructions)
2. Loosen the four bolts that fasten the motor to the bracket. This will allow the removal
of the motor.
3. Remove the motor pulley by loosening the set screw and slide the pulley off.
4. Install the pulley onto the new motor and slightly tighten the set screw.
5. Place new motor onto the mounting bracket and reinstall the four mounting bolts and
tighten.
6. Visually align the motor pulley and fan pulley by using the belt as a reference. Adjust
the motor pulley in or out to align. Tighten the motor pulley.
7. Loosen the four (4) bolts that secure the mounting bracket to the upright.
8. Lower the bracket slightly until the belt is tight (but not tight enough to overload the
motor), then tighten the four bracket bolts.
9. Replace the motor wires as marked from step #5. Replace wire ties to prevent cord
from getting in fan blade.
10. Replace motor wiring cover plate and inspect to be certain that the rubber seal is
properly seated.
11. Replace cooling pads and guards and reconnect power and test motor.
Pump Replacement (All Models)
1. Disconnect hose from pump.
2. Remove pump bracket.
3. Remove the 2 screws from the top of the electrical cord and unplug the cord by
pulling straight up from the top of the pump.
4. Remove pump from water sump and install new pump. Reverse the above
procedures to reconnect the wiring, pump bracket and the hose. Secure wires to fan
frame with wire ties to clear the fan blades.
5. Reinstall cooling pads and guards, reconnect power and test pump.

6.3 Technical support

Technical support and service is available directly from your distributor or
COOL-SPACE
®
Technical Support Hot Line at 001-317-577-0337
Visit:
www.cool-space.com
Email:
11