3M G5 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 3M G5. 3M G5 3 pagina's. Drive-thru systems
Ook voor 3M G5: Snelle referentiehandleiding (2 pagina's), Technisch bulletin (6 pagina's), Technisch bulletin (2 pagina's), Handmatig (10 pagina's), Technisch bulletin (12 pagina's), Handmatig (8 pagina's)

2. Identifying serial number on the XT-1 Headset / G5 Headset Components:

Follow the procedure below to disassemble the G5 Headset to it's individual components – The G5 Control Pod, the G5 Carrier

and the G5 Battery.

1. Remove the G5 battery from the G5 Headset

- Orient the headset in the position as shown in the illustration below.

- Position your thumb right under the latch and your index finger nail in the groove where the battery meets the headset.

- Now in one smooth motion and simultaneously push the battery latch up with your thumb while pulling the battery from the

housing with your index fingernail. This will release the battery.

- Using your finger nail, gently pull the discharged battery from the battery housing. Once dislodged, you may use your thumb

and remaining fingers to completely slide the battery out of the headset.

2. Separate the G5 Control Pod from the G5 Carrier

- On the opposite side of the G5 Headset Carrier, ensure that the G5 Control Pod Locking Mechanism is in the unlocked

position by sliding it all the way to the left. A small flat head screwdriver or other similar tool can be used to slide the locking

mechanism if needed.

- Insert your thumb into the battery cavity while securely holding on to the top of the G5 Carrier and gently separate the

G5 Control Pod from the G5 Carrier.

IMPORTANT NOTE: Make sure you DO NOT hold the G5 Control Pod battery tab with your thumb to separate the Pod from

the Carrier. Failing to do so may result in breaking of the battery tab.