Abseco AFi Series Installatiehandleiding - Pagina 14

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Abseco AFi Series. Abseco AFi Series 17 pagina's. Smart switch
Ook voor Abseco AFi Series: Installatiehandleiding (16 pagina's), Handmatig (17 pagina's), Installatiehandleiding (16 pagina's), Handmatig (16 pagina's), Installatiehandleiding (10 pagina's), Installatiehandleiding (16 pagina's), Handleiding voor productinstallatie (16 pagina's)

Pagina afdrukken
Product Familiarization & Installation Guide - Troubleshooting

Troubleshooting

If your smart switch is not operating correctly, perform the troubleshooting instructions
given below. If problem persists, contact your Abseco Smart Switch dealer or local
authorized Abseco service center.
FAULT
Not able to turn on the
smart switch (indicator
light on the smart switch
is OFF)
Light bulb not turning on
when smart switch is
turned on (indicator light
on smart switch is ON)
Not able to enable setup
mode on smart switch
®
Abseco
AFi Series Smart Switch - AFI-6M1S2P
PROBABLE CAUSE
No power supply or main
power supply is OFF.
Electrical connections to
the smart switch are
incorrect.
The light bulb is burned
out.
Electrical connections to
the smart switch are
incorrect.
Correct procedure for
enabling setup mode not
followed.
REMEDY
Make sure that power
supply is available and
the main power supply is
ON.
Make sure that the
electrical connections to
the smart switch are
correct. Refer to Wiring
Diagram given in
Installation Instructions.
Make sure that the light
bulb is in working
condition. If necessary,
use a light bulb that is in
working condition to
make sure that the fault is
not due to a burned out
light bulb.
Make sure that the
electrical connections to
the smart switch are
correct. Refer to Wiring
Diagram given in
Installation Instructions.
Press and hold ON/OFF
touch switch for at least
10 seconds and then
release. The indicator
light on the smart switch
will begin blinking to
confirm that setup mode
is enabled.
Page 15