Bose X Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Bose X. Bose X 36 pagina's. Installation of headset into cloth/leather helmet
Ook voor Bose X: Installatie (4 pagina's)

Pagina afdrukken

ETTING

OUR

EADSET

Figure 10

Installing the two batteries

Preparing the aircraft powered headset for use

EADY FOR

Inserting batteries

Insert the two supplied alkaline AA batteries (IEC LR6) into the

control module (Figure 10).

CAUTION: The battery compartment is designed to prevent inadvert-

ent reverse polarity from installing the batteries incorrectly. If the bat-

teries do not seem to fit correctly, do not force them in. Forcing an

improper connection will cause permanent damage to the control

module.

For an aircraft powered headset, the cable is permanently installed in

the aircraft.

CAUTION: The aircraft panel connector must be mounted by a

mechanic qualified to perform this type of avionics installation for the

aircraft you are using.

If yours is an aircraft powered headset, there is a connector on a 6-

foot wiring harness that came in the carton. This self-latching, preci-

sion designed quick-connector is designed for panel mounting and

mechanically keyed to ensure proper mating.

Attaching and removing the cable

When the quick-connector is installed, the cable leading from the

control module connects to it. Match the narrow bar on the cable

end to the slot on the connector. Press in until the two parts engage

(Figure 11 on page 15).

To release the cable, pull back on the sleeve near the end of the

cable. Then gently remove the cable from the connector.