Druck UNIK 5700 Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Druck UNIK 5700. Druck UNIK 5700 18 pagina's. Pressure sensing platform

medium to be measured is liquid. If there are water hammers in the system, it is recommended

to use a sensor complete with a hydraulic shock dampener.

To reduce the temperature acting on the isolation diaphragm when measuring vapor pressure, it

is recommended to use impulse tubes. The impulse tube must first be filled with water.

Attach the equipment in a safe configuration that prevents unwanted stress (vibration, physical

impact, shock, mechanical and thermal stresses). Do not install the equipment where it can be

damaged by a material that causes corrosion. Provide additional protection for the equipment if

it may be damaged in service.

When installing power supply and signal wiring, the possibility of condensate entering the sensor

cable entry should be avoided.

3.3 Connecting to a Pressure Source

When mounting the sensor, seal the mating surfaces. Failure to properly seal may affect

performance or calibration accuracy.

Male threaded pressure connectors must not be sealed or constrained against the face at the

base of the thread. The forward cone or flat face should always be used as indicated below.

English–UNIK 5*00 Series | 5