BED HANDLES BA11W Gebruiks-, montage- en installatie-instructies - Pagina 3

Blader online of download pdf Gebruiks-, montage- en installatie-instructies voor {categorie_naam} BED HANDLES BA11W. BED HANDLES BA11W 3 pagina's. Bedside assistant bed handle

Pagina afdrukken

Wrap the short strap

around your bed frame

and bring both ends of the

strap together.

Slide both ends through the

remaining slot as shown.

Connect the two ends of the buckle. A "click" is felt and heard when the buckle

latches. Pull on the ends of the long or short strap to tighten the bed handle against

the mattress. Test for tightness by trying to pull the bed handle away from the

mattress. The bed handle should not move or create a gap.

WARNING: SUFFOCATION AND STRANGULATION HAZARD

NEVER use bed handle without properly securing bed handle to bed.

Incorrect installation can allow bed handle to move away from mattress, which can

lead to entrapment and death.

Repeat Steps 1-8 for each safety retention strap and each bed handle.

Bed Handles can be on the same side or opposite sides of the bed.

CARE AND MAINTENANCE

 Periodically check safety retention straps to make sure they are tight, secure leaving no gaps.

 Do not use if any part is missing or damaged. Call (800) 725-6903 or visit BedHandles.com for

information on how to receive replacement parts.

 To remove the bed handles from the bed release buckles by squeezing on their sides.

Slide both ends through the

slot as shown.

NOTE: There is a top and bottom to a buckle.

Notice that the ribs on the center bar of the buckle

are on top. When properly assembled the strap

and buckle will not slip and loosen easily.

CAUTION: If the buckle is assembled while upside

down the strap will slip. Test after assembly is

complete to be sure the strap will tighten properly.

Page 3