DryAIR Hose Reel II Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DryAIR Hose Reel II. DryAIR Hose Reel II 20 pagina's.
Pagina afdrukkenSetup/Operation
Danger!
It is very important that you read and understand this section before operating the hose reel! Failure to follow the procedures and
cautions in this manual could lead to injury or possible death!
The DRYAIR hose reel has two methods (modes) of activation. There are also several controls that are factory set, and normally do not require
adjustment.
Manual Controls
The Hose Reel has an automated "UNLOAD/LOAD" actuated controller, a manual method of
controlling the spool rotational speed (RPM) and a general ON/OFF switch.
Spool Direction Controller
The toggle switch (1-1) controls the main power to the hose reel. The hose reel controller
defaults to the "Mode 1 - UNLOAD" upon powering up and engaging the "auto-feed
control". By connecting the foot switch, the controller switches to the "Mode 2 -LOAD" and
loads hose by depressing the foot switch which is momentary (will only operate when
depressed).
Mode 1 - UNLOAD
Mode 2 - LOAD
Mode 1 - "UNLOAD"
•
When the switch is toggled to the "ON" position, reel activation will automatically default to the "auto-feed control"
•
To use the "auto-feed control", pull the roller forward to activate the reel and feed out enough hose that the hose can be passed under the
roller.
•
Reel activation will now be automatic and the reel will "unload" the hose. When the hose is pulled in a direction away from the reel, the
hose will ride on the roller and cause the auto-feed arm to lift. When the auto-feed arm lifts, an attached plunger disengages from a limit
switch (internal) which, in turn, activates the reel.
Caution!
When NOT operating the reel, put the toggle switch in the "Off" position to prevent accidental activation and possible injury.
When the hose reel is to be left unsupervised, the power cord should be unplugged from the power supply.
Mode 2 - "LOAD"
•
When the switch is toggled to "ON" position and the foot switch connected to the hose reel, the reel will "load" the hose.
•
The foot switch is momentary and will only operate when it is depressed.
•
In the "LOAD" mode, the hose path should pass above the auto-feed mechanism roller.
•
The hose must be directed manually into position on the hose reel.
Caution!
Take care not to allow your hands, feet or clothing to become trapped by any of the reel's moving mechanisms.
Spool Rotational Speed
•
The adjustment knob (2-1) controls the reel R.P.M. Turning clockwise towards the "+" sign
to increase the RPM of the reel. Turn counter-clockwise towards the "-"sign to decrease the
R.P.M.
•
Range - 0 – 20 R.P.M.
•
RPM adjustment is required to ensure the operator maintain good control of the hose reel
operation.
•
In Mode 1 - "UNLOAD" - Set the reel RPM to a rate that prevents the auto-feed
mechanism from galloping. The reel RPM should be set at a rate that allows the operator to
maintain tension on the hose and, therefore, keep the auto-feed mechanism arm in a lifted
position.
•
In Mode 2 - "LOAD"- Set the reel RPM to a rate that allows the operator to maintain good
control of the loading process.
Setup/Operation
DANGER! WARNING!
1-1
1 - ON/OFF switch
2-1
2 - RPM controller
4-1