Drymatic Boost Bar Setup

Blader online of download pdf Setup voor {categorie_naam} Drymatic Boost Bar. Drymatic Boost Bar 3 pagina's.

DRYMATIC BOOST BAR - 90DEG ADAPTOR SETUP

The intended purpose of the Drymatic Boost Bar is to heat the airflow generated by a Centrifugal or Radial Air-Mover.

The system adds Heat Energy to the airflow, resulting in greater evaporation potential.

•

Read the Owner's Manual fully before setting up and operating the Drymatic Boost Bar

•

This presentation material offers set-up and use guidelines but DOES NOT substitute for fully reading the Owner's

Manual.

•

The Owner's Manual and additional product information can be found on

Operating as a Target Drying System:

The

Drymatic Boost Bar

can be used to raise the ambient temperature within tented chambers, voids, subfloor spaces,

and cavities. Increasing the temperature of the affected materials will result in an increase in evaporation potential.

This guide will walk you through the use of the Boost Bar with the

Step 1: The Drymatic Boost Bar should be placed in front of a centrifugal or radial airmover (not axial) – it is

recommended that the airmover have a similar outlet size to that of the Boost Bar. A

should be used to maximise airflow between the two units. The Boost to Fan connector is fixed using the

on either side of the connector, this allows for various outlet sizes.

Website: www.drymatic.com

https://facebook.com/DBKDrymatic

www.drymatic.com

90deg

Adaptor.

Fan to Boost Bar Connector

Fan to Boost Bar Connectors

The

Fan to Boost Bar Connectors

guide all of the airflow into the Boost Bar, increas-

ing pressure and air velocity out of the

Adaptor, but they also tether the Airmover and

Drymatic Boost Bar

together.

This reduces the risk of the policyholder seperat-

ing the two items on a claim and minimises the

chances of disruption to your drying regime.

Phone: +441443 237927

Velcro strap

not only help

90deg