DRYWISE 600591440003 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DRYWISE 600591440003. DRYWISE 600591440003 14 pagina's. Pre-heater add-on for drywise dryer

Pagina afdrukken
5.

Operation

5.1.

Recommendations

The Drywise Pre-Heater add-on must be installed to pre-condition a number of
material types, including but not limited to, reinforced nylons and a sub set of nylon
polymers. The add-on ensures that Drywise operates reliably and gives optimum
results with these filaments types. All the settings for the add-on are already pre-
saved on the Drywise dryer and no additional input is required from the user.
5.2.

Material compatibility

The Drywise Pre-Heater add-on is compatible with all material types which are
approved for drying with the Drywise in-line filament dryer. If the add-on is not
required for a specific material type it will be automatically disabled by Drywise. With
specific materials which require the add-on, the Drywise dryer will not function unless
the Drywise Pre-Heater is correctly installed and functional.
The Drywise dryer will automatically set the correct settings based on the filament
chosen.
It is essential to install the Drywise Pre-Heater to be able to use Drywise with the
following materials:
•
Carbon fibre filled nylons
•
Glass fibre filled nylons
•
Luvocom PAHT resin based filaments
•
Other specific materials as instructed by the Drywise UI.
The list of tested and approved materials is always growing. For an updated list kindly
check our website at drywise.co/materials.
DO NOT insert a different type of material other than that specific filament instructed
on the dryer and corresponding to that specific profile. Failure to observe this, could
result in damage to the filament and/or the device.
If the filament that you want to use does not have a profile, kindly check online or
reach out for help before trying to test with any other profile. Damage caused to the
device in this way will not be covered by warranty.
Designed for 2.85mm filament only.
10
Drywise Pre-Heater User Manual