DS Produkte CY-001 Instructies - Pagina 2

Blader online of download pdf Instructies voor {categorie_naam} DS Produkte CY-001. DS Produkte CY-001 4 pagina's. Led lights

EN
Dear customer,
We are delighted that you have decided on this set of LED lights.
If you have any questions, please contact customer service via our
www.service-shopping.de
website:
Proper use
The product is suitable for use as a lamp.
The product is not suitable for outdoor use.
The product is designed for private use and is not intended for
commercial use. Only use the product for the intended pur-
pose and only as described in the instructions. Any other use
is deemed improper.
Defects arising due to improper handling, damage or attempts
to repair the device are excluded from the warranty. This also
applies to normal wear and tear.
Safety notes
Risks of injury
Risk of suffocation! Keep the packaging material away from
children and animals.
Handling the batteries properly
Batteries may be life threatening if swallowed. Therefore keep
the batteries and product out of the reach of children and ani-
mals. If a battery has been swallowed, you must seek immedi-
ate medical attention.
Before inserting the batteries check that the contacts in the
battery compartments and on the batteries are clean and, if
necessary, clean them.
Only use the battery type specifi ed in the technical data (see
section "Technical data").
Always replace all batteries at the same time. Do not mix
different types or brands of batteries or batteries with diffe-
rent capacitance. When changing batteries ensure correct
polarity (+/-).
Remove the batteries from the battery compartments if they are
empty or if you are not using the product for an extended period.
This will prevent damage which can be caused by leakage.
If a battery has leaked, avoid contact of the battery acid with
skin, eyes and mucous membranes. In case of contact with
battery acid, rinse the affected area immediately with plenty of
clean water and seek immediate medical attention.
Immediately remove any leaking batteries from the battery
compartment. Clean the contacts before inserting new batte-
ries.
The batteries may not be charged or reactivated with other
means and they may not be disassembled, thrown in a fi re,
submerged in a liquid or short-circuited.
Handling the product properly
Only use the enclosed fastening material to hang up the pro-
duct. If you are unsure whether the enclosed mounting materi-
als are suitable for your wall, please fi rst consult an appropria-
tely qualifi ed outlet.
Hang the product in a place that is safe, secure and dry.
Before you drill a hole, ensure that there are no pipes or other
lines beneath the intended drilling site.
Children must be supervised in order to ensure that they do not
play with the product.
However, do not expose the product to extreme temperatures,
severe changes in temperature, direct sunlight or moisture.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
Product number: Z 04958
Do not allow the product to fall and do not subject it to severe
percussions.
This product may not be used in rooms with a high humidity
such as bathrooms.
Maintain adequate distance to candles, fi replaces, stovetops or
other fi re and heat sources.
Ensure that the product cannot fall into water.
If the product is defective, do not attempt to repair it yourself. In
the event of damage, contact customer service.
When needed, wipe the product off with a dust cloth.
Product contents
4 x LED light
4 x 2 screws and dowels
4 x suspension device with adhesive strip
You need additionally 3 x 1.5 V batteries, type AAA for each LED
light. They are not included in the product contents.
Start-up
The lamp is individually moveable.
1. Open the battery compartment on the back of the lamp by
pressing the locking lug down and fl ipping up the battery com-
partment.
2. Insert 3 x 1.5 V batteries, type AAA in the battery compartment.
Make sure the polarity (+/-) is correct. They are not included in
the product contents.
3. Attach the suspension device at a suitable place. The type of
fastening materials depends on the composition of the wall.
Please also be absolutely sure to observe the safety notes for
installation.
4. Secure the LED light to the suspension device.
5. Pull on the cord once to switch on the lamp. Pull on the cord
once more to switch the lamp off again.
Technical data
Model:
Voltage supply:
Disposal
The packaging material can be recycled. Dispose of the pa-
ckaging in an environmentally-friendly manner and make it
available for the recyclable material collection-service.
Dispose of the product in an environmentally-friendly man-
ner. The product does not belong in the household garbage.
Dispose of it at a recycling centre for old electrical and elec-
tronic appliances. For more information, please contact the
administration in your community.
Non-rechargeable and rechargeable batteries should be re-
moved prior to disposal of the device and disposed of sepa-
rately from the device. To protect the environment, non-re-
chargeable and rechargeable batteries may not be disposed
of with the normal household waste, but must be taken to
suitable collection points. Also note the relevant statutory re-
gulations governing the disposal of batteries.
Customer Service / Importer:
All rights reserved.
CY-001
4,5 V DC (3 x 1.5 V batteries, type AAA)
+49 38851 314650 *)
Instructions
Z 04958_V1_12_2015