DS18 HOOLIGAN KO H-K03 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DS18 HOOLIGAN KO H-K03. DS18 HOOLIGAN KO H-K03 13 pagina's. Competition spl monoblock; class d
Pagina afdrukken
BASS BOOST
DS18 H-KO amplifiers have
an adjustable bass boost.
Begin your adjustments at
low volume. If you do not
hear any improvement
then woofer does not
need any bass boost.
Use Bass Boost carefully.
The demands on power
output are tremendous.
Try to minimize the use by changing woofer position or the enclosure size.
SPEAKER OUTPUTS
This amplifier is equipped
with a large block style
terminal for speaker
connection. Make this
connection carefully and
neatly. Strip your wire
back and twist the
exposed leads and insert
them into the block
terminal while being
careful that there is no
loose or frayed strands of
wire and tighten the Allen head screw down on the terminal till the wire is tightly
secured in place. If the wires ever come in contact with each other the amplifier
will go into protection.
INSTALLATION INSTRUCTIONS
1.
Before you start, disconnect the negative cable from the car battery.
Tape up the end so it is isolated from the battery.
2.
Run an appropriate gauge wire from the battery to the amplifier. Plan this part
of the installation carefully. This cable will carry very high current, if it should
short to the body and it is not properly fused it could catch fire.
3.
Connect the power wire to the battery using a fuse capable of the total current
load of all amplifiers connected. Don't install the fuse yet. Wait until the end.
Locate the fuse as close as possible to the battery. If the fuse is further than 18
inches (wire length) from the battery you should reevaluate the wire and fuse
placement.
4.
Find the closest clear metal area to the amp for a ground. Sand, grind or
scrape all paint and undercoating from the body and screw the ground
securely in place.
4