Daintree GE current Tetra EdgeStrip HO GEBIH50-2 Installatiehandleiding - Pagina 3

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Daintree GE current Tetra EdgeStrip HO GEBIH50-2. Daintree GE current Tetra EdgeStrip HO GEBIH50-2 5 pagina's.

Pagina afdrukken

Tetra

EdgeStrip HO

Electrical Connections

NOTE: Refer to the power supply installation instructions for loading and remote mounting information.

NOTE: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease

to seal connections.

Connect modules using twist-on wire connectors

or in-line (IDC) connectors. Join white wires

together and red striped wires together.

NOTE: Additional supply wire may be necessary to

bridge electrical connections.

To LED System

Power

Supply

Run a wire from the Power Supply and connect to

the first LED module on the strip.

Must be used with Tetra

NOTE: All electrical connections should be suitably protected from mechanical damage and the environment. Seal all

connections in locations that may be exposed to water with electrical grade RTV silicone.

24 Volt Power Supplies.

Cap all exposed wires with appropriate end caps

or apply electric grade (non-conductive) silicone

for additional weather protection.

Connect the red stripe wire (+) of the LED

system to the red wire (+) of the power supply.

Connect the white wire (-) of the LED system to

the black or blue wire (-) of the power supply.

NOTE: All electrical connections should be

made within the box sign.

Installation Guide

To Power

Supply