DSAN Limitimer ASL4-ND3 Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} DSAN Limitimer ASL4-ND3. DSAN Limitimer ASL4-ND3 5 pagina's. Speaker timer with remote signal light

Pagina afdrukken

Global Settings

Global settings are common to all programs. They are made on the 12-position DIP switch

on the rear of the timer console. The default settings (shown) are suitable for most uses.

1. Master / Slave.

When two or more timers are connected to one or

more signal lights, set one timer as master [ON]

and the other(s) as slave [OFF]. When only one

timer is used, it must be a master (default setting).

"Master" Switch 1 = ON

The Slave timer acts as a client sending keystroke

commands to control the Master and displaying the

time remaining. All the time processing is done in

the Master.

2. Counting Program 4 (Session)

Minutes:Seconds (ON); Hours:Minutes (OFF)

When using Program 4 to time a program over

several hours, set to Hours:Minutes (OFF).

3. Counting Program 1, 2 or 3

Minutes:Seconds (ON) Hours:Minutes (OFF)

Wireless Operation

11 + 12. Wireless Channels (PRO-2000BT)

PRO-2000BT is equipped with an integrated

Bluetooth transceiver. It can communicate with up

to 6 Bluetooth signal light receivers (TR-2000BT) or

other PRO-2000BT timers on

four different channels. This

allows multiple timer-signal

light networks to operate in

proximity. Match receiver

channel (rotary switch) with

timer channel (DIP switches 11

+ 12) as shown. Note:

Receiver channels 0,4,5,6 not used. The effective

distance for wireless communications is about

"Slave" Switch 1 = OFF

4. Count direction

Count-Down [ON] or Count-Up [(OFF].

If Count-Up, Time Remaining display shows

elapsed time, else Time Remaining.

5. Count Behavior

Continue after zero [ON] else, stop display at zero.

Note, in OFF mode, clock continues to run and red

light stays on until user presses "Stop."

6. Sound Volume

High (ON) Low (OFF)

7.+ 8. Sound Selection

7. ON 8. ON None*

7. OFF 8. ON Buzz

7. ON 8. OFF Ring

7. OFF 8. OFF Chime

9. Time Settings Permission

Allow time changes while clock is running [ON].

10. Block Transmitter [ON]

Model PRO-2000BT offers wireless transmission to

the remote signal light. Set to "OFF" when using a

wireless connection.

60-feet. Bluetooth devices need to "find" one

another before communicating. This process is

called "pairing." To pair signal light receiver(s) with

a timer, keep the devices close (< 30-feet) until the

yellow Connection LED turns green. This indicates

that the devices are communicating.

Bluetooth

Connection LED

Default settings

1 2 3 4 5 6 7 8 9

*An empty sound. "Beep"

pressed on the timer

outputs a cue to activate a

sound at a signal light that

is set for an audible sound.

1112