DSB 330 ARP Gebruiksaanwijzing

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DSB 330 ARP. DSB 330 ARP 2 pagina's. A3

Pagina afdrukken

330ARP

COLD Lamination

(see Fig-3)

After the laminator has been turned on using the tempera-

ture transfer switch located on "0" position, the cold mode

is automatically set. If the machine has just recently been

used for hot lamination, then the machine must reach a

。

temperature of no more than 25

before starting cold

lamination.

1. Select a no-heat laminate that is slightly large than the document to be laminated.

2. Run the film, film-side faced up, for about 3~6mm into the laminator, and then press POWER BUTTON

to stop the rollers.

3. Carefully separate the baking release paper from the film, and drape the clear film over the top of the

laminator.

4. Place the document between the separated film and backing.

5. Then press the power switch to finish laminating.

Cautions item:

Cleaning

Warning : please make sure that the machine has been turned off and unplugged before cleaning.

As to the smutch on the covers of the machine, please wipe them off by cloth.

Service:

Do not attempt to service or repair the pouch laminator yourself. Unplug the unit and contact an

authorized service representative for any required repairs.

Technology data

Heating system

Hot shoe + heating plate

Laminating type

Cold & hot laminating

Laminating speed

750~800mm/min

Laminating thickness

1mm

Warm up time

3~3.5min

Roller quantity

Max. entrance width

330mm

Available thickness

75~250mic

baking release paper

document

film draped

the laminator

(see Fig-3)

330ARP

A3 LAMINATOR

I n s t r u c t i o n M a n u a l

Model No:330 ARP

WARNING：

For your protection, do not connect the pouch laminator to electrical

power until you read this instruction completely. Keep this instruction in a

convenient location for future reference.