DAIRY EQUIPMENT Dari-Kool Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DAIRY EQUIPMENT Dari-Kool. DAIRY EQUIPMENT Dari-Kool 14 pagina's. Bulk milk cooler

Pagina afdrukken
To read the measuring stick it i nece ary to remove it
from the cooler and thoroughl.
sh it.
eplace in tank
and remove it noting the scale reading, then gcing to your
chart you can determine how much milk you have in the Lank.
Listed below are some "DO. T'Ts" to follow:
1. DON'T
use steel wool.
Particles of this may adhere to
the stainless steel and later show up as rust.
2. 00 'T allow
cleansers
or sterilizers
to remain
n
stainless steel longer than necessary.
3.
DON'T
allow non-stainless metal to lie on stainless
steel surfaces.
4.
DON'T
use full strength acids for removing milk stone
Acid cleaners may be used if you follow the recommenda­
tions of the manufacturer.
5.
DON'T
use water with high mineral content without
wiping excess frQm the surface being cleaned.
6.
DON'T
leave the switch controlling the pump and agitator
in "ON" position when tank is empty.
It is probably
best if you check with your milk hauler on this as he
can turn it "OFF" when he empties the tank.
7.
DON'T
tamper with the controls, motor or unit on cooler.
(Tampering can void warranty).
8.
DON'T
spray waLeI' directly on any motor.
9.
DON'T
turn off main switch to condensing uniL.
The following "DOs" will aid you in gaining maximum
benefits from your DARI-KOOL BULK MILK COOLER.
1. DO
clean your cooler properly, both the interior and
exterior.
(See "Care of Stainless Steel" which accom­
panies these instructions).
2.
DO
check and see that your pump and agitator switch is
in "0 "position before adding milk.
3.
DO
set timer about
10
or 15 minutes prior to adding
milk to tank.
4.
DO
read thermometer-this will indicate whether co leI'
is performing satisfactorily.
8. TROUBLE
If you notice that your compressor is n
t
performing ::md
there is no ice around the control bulb w suggest the r,.,l_
lowing points be checked before contacting your dealer.
- 5 ­