DSC Envoy NT9010 Gebruikershandleiding - Pagina 20

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DSC Envoy NT9010. DSC Envoy NT9010 20 pagina's. Demo stand
Ook voor DSC Envoy NT9010: Installatie-instructies (4 pagina's)

Pagina afdrukken

Intrusion

A steady siren means an intrusion alarm. The system may also announce the label

(Burglary)

for the zone(s) that triggered the alarm, if programmed by the installer.

Alarms

To silence the alarm:

1. Enter your [access code].

2. If the alarm was unintentional, call your central station immediately to avoid an

unnecessary response.

3. Check the alarm memory to see which zone caused the alarm.

Once the source of the alarm has been corrected, the system will return to the

Ready state.

Central

If your installer has set up remote monitoring on your system, the talk/listen-in fea-

Station Talk/

ture may also be available. If an alarm, or other programmed event, occurs on

Listen-in

your system, this feature allows a central station operator to listen to what is hap-

pening on the premises. The operator may also be able to talk to whoever is

present, depending on the type of event that has occurred. Ask your installer for

more information on this feature and how it works.

Checking

The alarm memory announcement tells you which zone (detector) caused the

Alarms in

alarm. The alarm memory is cleared each time the system is turned on. Any alarms

Memory

announced by the system have only occurred the last time the system was on.

CAUTION: If you return and find that there was an alarm while you were

away, it is possible that an intruder may still be on the premises. Go to a

nearby safe location, and call your central station or the local authorities to

investigate.

If an alarm occurred while the system was turned on, the NT9010 will announce:

"There are (number) alarms in memory: {Zone XX}.".

1. To cancel the alarm memory announcement, press

2. After the announcement is over, the system will return to the Ready state, but

the yellow (System) light will be ON. To listen to alarms in memory again, press

. The NT9010 will announce the zones that were in alarm.

Calling for

The NT9010 has three pairs of emergency keys. Using these keys you can send an

Help

immediate Fire, Auxiliary or Medical and Panic message to your central station.

IMPORTANT:The Fire, Auxiliary or Medical, and Panic keys will NOT func-

tion unless they have been turned ON by the installer. If your installer has

turned these keys ON, and enabled audible feedback, holding down the

keys for two seconds will cause the keypad sounder to beep indicating that

the alarm input has been accepted and transmission to the central station

is underway.

From the NT9010 controller

Press both

keys for two seconds to send a Fire message, and to trigger a

fire alarm on the system.

Press both

keys for two seconds to send an Auxiliary message.

Press both

keys for two seconds to send a Panic message.

Press both

keys (if available) for two seconds to send a Medical message.

NOTE: In the U.S.A., do not program the Aux keys for use in medical emer-

gencies as per UL requirements.

De ali n g Wi th Al arm s a nd E m erg e nc ie s