DSC PC500 Gebruiksaanwijzing - Pagina 9
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DSC PC500. DSC PC500 14 pagina's. With pc5oork keypad
Ook voor DSC PC500: Gebruiksaanwijzing (13 pagina's), Gebruiksaanwijzing (13 pagina's)
Pagina afdrukken
is entered, the Armed light will come ON and the Exit Delay will begin; you may now leave the premises
through the Entry-Exit door. At the end of the Exit Delay, the system will be fully armed.
DISPLAYING SYSTEM INFORMATION
System Light
The "System" light will come ON when:
• there are Bypassed Zones on the system
• there are alarms in Alarm Memory
• there is a Trouble Condition present on the system.
If the "System" light is ON, use the commands described on this page to view bypassed zones, to display
zones that went into alarm when the system was last armed, or to display trouble conditions.
Display Bypassed Zones
Enter [ ][1][Access Code] to display any bypassed zones on the system. If a zone is bypassed, its zone light
will come ON when this command is entered. Before arming the system, ensure that the zones indicated on
the display are intentionally bypassed.
Display Alarm Memory
When a zone generates an alarm, the alarm will be recorded in the system's Alarm Memory. To display the
zones that went into alarm, enter [ ][3]. The "System" light will FLASH, and the zones that went into alarm
will be displayed on the flashing Zone Lights.
Display Trouble Conditions
The PC500 constantly monitors itself to ensure proper operation. When a condition occurs that could
affect operation, the "System" light will come ON to indicate that there is a trouble condition present on
the system. If both trouble conditions are present on the system, the keypad will sound two short beeps
every 10 seconds to warn of the problems.
To silence the sounder, press the [#] Key. The keypad will be silenced, but the "System" light will remain
ON until the trouble condition is cleared.
To display the trouble conditions, enter [ ][2]. Trouble conditions are represented with the Zone Lights; if
a Zone Light comes ON, then that trouble condition is present:
Zone Light
Trouble
1
Battery Trouble
2
AC Failure
8
Cause
Battery is low
Electricity to system is off
What To Do
Call for service
Check your fusebox or
circuit breakers; call for
service if the trouble
cannot be corrected