DSE RE-BCC8FD Gebruikershandleiding
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DSE RE-BCC8FD. DSE RE-BCC8FD 3 pagina's.
Pagina afdrukken
OWNER'S MANUAL
RE-BCC8FD
PRODUCT DESCRIPTION
This camera is made to allow the resumption of license
plates of vehicles in slow or fast motion. It can operate in
any
light
condition
thanks
illuminators. Thanks to a High-Light Suppression system is
not influenced by the headlights of the vehicle is that
dipped beam.
ASSEMBLY
The cameras are equipped with a mounting bracket for
wall built to allow the passage of cables within it. The
bracket is mounted generally at the output cables. The
fixing base has 4 holes for fixing to the wall with dowels.
The housing is waterproof and can be installed outdoors
without any protection.
The housing is air-conditioned and is equipped with a fan
which is activated at above 45 ° and a heater that is
activated at below -5 ° C.
POSITIONING
The positioning of the camera it is very important for a
good yield of the license plate reading.
The optimal recovery of the plate is carried out at a
maximum distance of 30 m. depending on the adjustment
of the lens.
The first thing to check is therefore that the distance as
the crow flies (not walkable on the ground) between the
camera and the point where you will find the means, does
not exceed this distance otherwise the infrared lighting
will not be effective.
The second thing to consider is to position the camera so
that the light of the headlights is not directly oriented
towards the camera, while maintaining an angle of
approximately 30 ° with respect to the illumination of the
headlights. The camera will then be placed in detected
position with respect to the road surface so as to avoid
that the dot headlights directly against the camera.
Satisfied 2 above, orienting the camera needs to be done
so that the plate remains as long as possible in the field of
vision of the camera.
RE-BCC8FD camera license plate
to
the
built-in
infrared
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
SENSOR BRIGHTNESS 'BACK
The camera is equipped with a CDS sensor which allows to
detect the ambient light and is placed posteriorly to avoid
false detections due to the headlights of cars. The sensor
is placed in the rear of the housing grommet.
Absolutely necessary to avoid that light sources should be
to distort the detection of this sensor, because in this case
the camera will not operate properly at night. Above all
we must avoid the presence of illumination lights around
the camera that would prevent the LEDs.
CONNECTIONS
The connections on the output cable from the camera are
the following:
BNC video output - At the BNC bayonet socket
connecting the video cable which then leads to a AHD
DVR.
The
RE-BCC8FD
cameras
are cameras able to work
only with DVR AHD last
generation
able
to
will
handle the full HD 1080P 1920x1080 (2 MP). The old
analog CVBS video is no longer supported.
pin DC12V - must connect a 12VDC power supply
stabilized by at least 2,000 mA, such as RE-AL5 model
(not included).
The requested plug is the standard 5.5 mm. Attention to
use STABILIZED feeders that provide 12V in any load
condition. The use of a different supply voltage from
12VDC can generate video disorders and in the worst
cases damage the camera. Attention to extension cables
power too long or small section, which could introduce an
excessive fall of species voltage at power IR illuminator.
RS485 port- This connection allows you to connect an
RS485 BUS which serves to remotely control the IR
Document: RE-BCC8FD 2C0
Page: 1