AirTime AT12RPS Installatie- en gebruikershandleiding - Pagina 3
Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} AirTime AT12RPS. AirTime AT12RPS 6 pagina's. Solar powered wall clock
Ook voor AirTime AT12RPS: Installatie- en gebruikershandleiding (4 pagina's)
Pagina afdrukkenLimited One-Year Limited Warranty
Lathem warrants the hardware products described in this guide against defects
in material and workmanship for a period of one year from date of original
purchase from Lathem or from an authorized Lathem reseller. The conditions
of this warranty and the extent of the responsibility of Lathem Time
Corporation ("Lathem") under this warranty are listed below.
1. This warranty will become void when service performed by anyone other
than an approved Lathem warranty service dealer results in damage to the
product.
2. This warranty does not apply to any product which has been subject to abuse,
neglect, or accident, or which has had the serial number altered or removed,
or which has been connected, installed, adjusted, or repaired other than in
accordance with instructions furnished by Lathem.
3. This warranty does not cover dealer labor cost for removing and reinstalling
the machine for repair, or any expendable parts that are readily replaced due
to normal use.
4. The sole responsibility of Lathem under this warranty shall be limited to
repair of this product, or replacement thereof, at the sole discretion of Lathem.
5. If it becomes necessary to send the product or any defective part to Lathem
or any authorized service dealer, the product must be shipped in its original
carton or equivalent, fully insured with shipping charges prepaid. Lathem will
not assume any responsibility for any loss or damage incurred in shipping.
6. WARRANTY DISCLAIMER AND LIMITATION OF LIABILITY: Except only the
limited express warranty set forth above, the products are sold with no
expressed or implied warranties of any kind, and the implied warranties of
merchantability and fitness for a particular purpose are hereby expressly
disclaimed. No warranties are given with respect to products purchased other
than from Lathem or an authorized Lathem reseller and any such products are
purchased "as is, with all faults." In no event will Lathem be liable for any
direct, indirect, special, incidental or consequential damages arising out of or
in connection with the delivery, use or inability to use, or performance of this
product. In the event any limited remedy given herein shall be deemed to
have failed of its essential purpose, Lathem's maximum liability shall be to
refund the purchase price upon return of the product.
7. Proof of date of purchase from Lathem or an authorized Lathem reseller is
required for warranty service on this product.
8. This Warranty grants specific legal rights. Additional legal rights, which may
vary by locale, may also apply.
9. Should any difficulties arise with the performance of this product during
warranty, or with any Lathem authorized service centers, contact Lathem Time
at the following:
Lathem Time
200 Selig Drive SW
Atlanta, GA 30336
Phone: 404-691-0405 Fax: 404-696-6048
Online: www.lathem.com
Patent Pending
Installation & User's Guide
Page 9
AirTime Solar Wall Clock
Quick Install Steps
Important: Before installing the wall clock, verify that an
AirTime Transceiver is installed and properly transmitting. You
should manually initiate the transmission of the AirTime signal
by pressing the TRANS button on the front of your transceiver.
If an AirTime transceiver is unavailable, you can still install the
clock and set to the current time (see "Setting the Time
Manually" on page 7).
1. Insert the supplied lithium battery (CR123A) into the
battery compartment on the back of the clock.
2. Turn the clock on, by sliding the Power Switch to the Start
position.
3. Press the Reset button on the back of the clock to begin
listening for the AirTime correction signal.
4. The LED on the front of the clock will flash
two (2) seconds.
5. When the signal is received, the LED will flash
second and correction will occur. When correction is
complete, the LED will stop flashing.
Page 2
green
every
green
every
Doc. No. USG0080A