AirTime ATX6 Installatie- en gebruikershandleiding - Pagina 11

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} AirTime ATX6. AirTime ATX6 16 pagina's. Wireless wall clock transceiver

Pagina afdrukken
ATX6 Installation and User Guide
ATX Receiving WWVB signal synchronizing an ATX 6 correcting
Wireless Wall Clocks and LTR Master
ATX6 through an external amplifier correcting Wireless Wall
Clocks (Requires function 19 of ATX6 be set to "1")
Page 19
4
Hours
(00 ~ 12 AM/PM)
Use the INC button to advance through the values. Advancing
past '11' will also toggle the AM and PM indicators. Press the SET
button when the correct value is displayed.
5
Minutes
(00 ~ 59)
Use the INC button to change the value of the first digit. Use the
NXT button to move the cursor to the next digit, and then use
the INC button to change the selected digit. Press the SET button
when the correct value is displayed.
Press SET after this step to set seconds to :00. For the most
precise manual time setting, increment the displayed value to
represent the up-coming minute. Then, at the start of the new
minute, press the SET button to record the programmed MM-DD-
YY
HH:MM:00.

Parameter Set-Up:

To enter the Parameter Set-Up Mode, simultaneously press the
Left (INC) and Center (NXT) buttons for 1 second. You will see
the Password prompt: "P000". For each of the following
parameters to be set, the display will show the parameter
number in the two left digit positions, and the parameter value
in the two right digit positions. The parameters are as follows:
P
Awaiting Password
(000 ~ 999)
If you have not previously changed the password, press the SET
button to continue [Default Password is '000']. If you have
previously changed the Password, enter the value using the INC,
NXT and SET buttons. The INC button will increment the digit
over the displayed cursor. The NXT button will move the cursor
to point to the next digit. The SET button will enter your final
selection. If correct, the display will advance to enter the first
set-up parameter.
If incorrect, an "Err" message will be displayed. Press the Set
button to re-enter your password. Press Inc or Next to abort the
setup.
ATX6 Installation and User Guide
Page 8