Atsumi Electric IR36E Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Atsumi Electric IR36E. Atsumi Electric IR36E 8 pagina's. Passive infrared detector

Pagina afdrukken

(2) 2 detectors (3 - 4 , Form B used)

Power

Output

Alarm

Input

Tamper

Controller

To maintain stable performance, use the same kind of wire for all purposes, Power, Tamper, Alarm and Alarm memory.

Do not supply power until all wiring is completed.

Connect the unit to a UL listed power supply or control panel capable of providing stand-by power for at least 4 hours.

Refer to the National Electrical Code, NFPA70.

INSTALLATION

1Loosen the lock screw then turn the sensor unit counter-

clockwise to remove it from the base unit.

3Perform initial setup. Please see '' 7. Initial setup'' for details.

4Determine coverage. Please see '' 8. Determining Coverage'' for details.

5Mach direction of both arrows then align V-shaped protrusion A of the sensor unit with Mark B of the base unit. Then turn the

sensor unit clockwise until matching Mark C.

6Mount the sensor unit to the base unit using the lock screw.

Install the unit so that intruders will cross field of view. Please see Section ''11 Coverage'' for details.

Arrows

Detector

2Mount the base unit on ceiling and connect the wire to the

unit.

Knockout

Detector

Wiring hole

Mark B

Mark C

V-shaped protrusion A