3One data IES608-2F Hardware installatiehandleiding - Pagina 9

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} 3One data IES608-2F. 3One data IES608-2F 11 pagina's. 8-port 10/100m industrial ethernet switch

Pagina afdrukken

series adopt 35mm DIN-Rail installation, the installation steps as

fellows:

1. Examine the DIN-Rail attachment

2. Examine DIN Rail whether be firm and the position be

suitability or not.

3. Insert the top of the DIN-Rail into the slot just below the stiff

metal spring.

4. The DIN-Rail attachment unit will snap into place as shown

below.

Wiring

Requirements

Wiring

Wiring Requirements

Requirements

Be sure to disconnect the power cord before installing and/or wiring

your Ethernet Switch.

Calculate the maximum possible current in each power wire and

common wire. Observe all electrical codes dictating the maximum

current allowable for each wire size. If the current goes above the

maximum ratings, the wiring could overheat may causing serious

damage to your equipment. You should also pay attention to the

following items:

1. Use separate path to route wiring for power and devices. If power

wiring and device wiring paths must cross make sure the wires

are perpendicular at the intersection point.

2. NOTE: Do not run signal or communications wiring and power

wiring in the same wire conduit. To avoid interference, wires

with different signal characteristics should be routed separately.

3. You can use the type of signal transmitted through a wire to

determine which wires should be kept separate. The rule of

YourSerial and Data Communications Expert

Shenzhen 3onedata T echnologyCo.,Ltd