Atten ST 100 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Atten ST 100. Atten ST 100 16 pagina's.

touchtone se�ng mode and display panel will show current touchtone se�ng status. Press

to set touchtone state and press #3 to save it.

Note: Beeping function is enable as setting content is "ON", and now there will arise short beep for

each operation on control panel to call your attention.

13. Restore factory se�ngs

12.1 In system se�ng mode, press

factory se�ngs restora�on mode. Press

soldering sta�on system se�ngs will be reset as follows:

CAL (User temperature calibra�on value): Cleared.

FIN (ﬁne tuning): OFF

C F (Temperature scales): Celsius

STB (Automa�c Standby): OFF

SDN (Automa�c shutdown): OFF

BL (Beeping): ON

Express temperature 1: 200

Express temperature 2: 300

Express temperature 3: 400

14. Exi�ng system se�ng quickly

14.1 In system se�ng mode, press

system se�ng mode quickly(Default automa�c exi�ng �me is 10 seconds),then press #2 to exit

system se�ng mode.

Maintenance

To ensure this product lifespan will not be shortened, user must pay a�en�on to following

ma�ers in using this product.

Do not use this equipment for other purposes except soldering work.

Do not rack soldering irons handle to remove residue solder on soldering �p which will damage

this unit.

Do not tamper with this product and its internal components.

Do not modify this product and its internal parts.

Please choose accessories produced by original manufacturer for replacing parts.

Please grasp plug rather than cables for pulling plug out.

Troubleshoo�ng

Fault Code Or Malfunc�on Descrip�on

E 0:Abnormal hea�ng alarm of heater.

Figure 21

to go to third se�ng page(Figure 8). Then press #1 to enter

to choose rese�ng page or not. A�er rese�ng,

to go to third se�ng page(Figure 8) as user want to exit

Causes For Malfunc�on

Transformer damaged

Power MOSFET damaged

Figure 22