ATTIAS USA-80 Installatie en bediening - Pagina 7

Blader online of download pdf Installatie en bediening voor {categorie_naam} ATTIAS USA-80. ATTIAS USA-80 11 pagina's. Commercial dough mixers

A Drain Plug is located on the bottom of the planetary. Should draining become

necessary, remove the Drip Cup- Splash Guard and place a suitable catch pan under the

draining plug. Remove the drain plug, allow oil to completely drain, and replace the

drain plug. Remove the fill plug and pour in six fluid ounces of the recommended

planetary lubricant. Replace the Fill Plug and the Drip Cup-Splash Guard. Contact

ATTIAS OVEN CORP. for the recommended planetary lubricant.

Planetary Seal

Occasionally, the planetary seal may become dry and begin to squeak. To correct this,

work a little lubrication under the lip of the seal.

Transmission

The transmission oil should be even with the line on the Oil Level Gauge when the

motor is NOT running. If the oil falls below this line, DISCONNECT ELECTRICAL POWER

SUPPLY and remove the Top Cover, which is secured by two screws. Remove the

Transmission Fill Plug and add a small amount of the recommended transmission oil

until it returns to the proper level.

DO NOT overfill the transmission as leakage may result. Contact you ATTIAS OVEN

CORP. for the recommended transmission oil.

Bowl Lift

The slideways and lift screw should be lubricated approximately twice a year. To reach

these areas, fully lower the bowl support and remove the apron, which is secured by

four thumb screws. Wipe a thin coat of lubricate on the bowl clamp area of the bowl

supports, each slide way, and the lift screw. Replace the apron.

Note: on units with a manual bowl lift, the handwheel gearing should be lubricated

periodically. To do this, DISCONNECT ELECTRICAL POWER SUPPLY and remove the top

cover. Wipe a coat of Lubricate on the gear teeth and replace the top cover.

ADJUSTMENTS

AGITATOR CLEARANCE

The agitator clearance should be checked with each bowl change. The agitator must

not touch the bowl and the maximum clearance between the bottom of the bowl and

the Flat Beater is 1/8"; the maximum clearance between the bottom of the bowl and

the Dough Arm is 5/16".

Install a Bowl and Agitator. If the Bowl and Beater come into contact before the Bowl

Support reaches its stop, adjust the Stop Screw upwards following the procedure below.