DT Research DT381RP Basishandleiding - Pagina 4
Blader online of download pdf Basishandleiding voor {categorie_naam} DT Research DT381RP. DT Research DT381RP 5 pagina's. Rugged tablet
User may "Press, briefly hold and release (Right-click)" the
This pop-up menu allows user to choose from a selection of options (e.g., About, Help)
related to the application and its usage.
Notably, under Help, the user is able to view locally (on-device) a tutorial on the usage
of the tool or application.
Wireless Networking
Wireless LAN
The DT381RP is often delivered with an embedded (user-inaccessible) 802.11ax LAN
adapter equipped with a hidden custom antenna.
•
Through the support of typical WLAN adapters, the DT381RP should be able to
detect all 802.11 access points in the vicinity for you to select the access point of
your choice for connection.
•
The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT362G and the
access points have to match. The SSID is case-sensitive and it is recommended
that you enable WEP/WPA/WPA2 encryption (or advanced alternatives) for
secure access.
•
When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly configure
associated settings such as Authentication mode, etc.
•
Refer to the access point operating manuals for setting up the 802.11 access
points.
USING THE TABLET
To Hold the Tablet
Left hand: grip the left back side of the tablet with your
left hand four index fingers, with thumb resting on the
top of the back side of the tablet and palm securely
against the back.
Right hand: grip the right back side of the tablet with
your right hand four index fingers, with thumb resting
on the top of the back side of the tablet and palm
securely against the back.
6
icon to launch a pop-up menu.
Replacing the Battery Pack
1. Slide the battery latch to the unlocked position.
2. Lift the battery pack off the compartment.
3. Fit another battery pack into place.
4. Slide the latch to the locked position.
5. If you want to purchase extra battery packs, please
contact your dealers, or visit our Support page:
https://www.dtresearch.com/en/Support/contact.html
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Replace the
battery only with the Tablet manufacturer's battery. Discard used batteries
according to the dealer's instructions.
CAUTION:
Do not attempt to disassemble the battery pack.
Battery Usage and Maintenance
DT Research tablets and laptops are powered by lithium polymer battery packs in
proprietary form factors. Battery configurations for the DT Research devices include
internal (bridge or backup), removable or swappable implementations.
Battery usage cycles, or duration between necessary re-charge, vary with a number
of factors, including device model, device usage pattern and battery health/aging.
The DTR battery packs may be charged while attached to the device or when sepa-
rated from the device and docked in proprietary battery charging cradles. Following
the guidelines on good practice below can help to keep a battery pack healthy and
prolong battery usage cycles and battery lifespan.
Avoid high heat conditions during operation, idle, charging, and storage
•
states.
Avoid letting the battery pack remain in very highly charged state or overly
•
low charged state for extensive periods of time. Keeping the battery capacity be-
tween 30% and 80% of maximum capacity is recommended. The prevailing battery
level(s) can be read from the Battery utility within the Windows operating system.
Avoid letting the battery be over-discharged or depleted. Over-discharge can
•
occur when a fully-discharged (0% level or thereabouts) battery pack is allowed to
remain in such a state for an extended period of time (weeks or months). The em-
bedded battery controls enter a protection mode and recharging will be prevented
for safety reasons. To reduce the likelihood of over-discharge, consider recharging
idle batteries regularly to some level between 30%-80% of capacity.
For long term storage, it is recommended that removable battery packs
•
be stored separated from the device. Otherwise, the system should be placed in
Shutdown mode. The battery level will decrease with time and it is recommended
that the battery packs be monitored or recharged every 2-3 months to maintain
1
2
1
3
4
7