DTAR Wave-Length Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} DTAR Wave-Length. DTAR Wave-Length 16 pagina's. Under saddle transducer
Pagina afdrukken
Important Notes – Read First
1. Although it is possible for a skilled end user to install this
pickup system, for optimum results, we recommend
installation by a professional luthier.
2. Avoid any rough handling of the pickup. Bending, kinking or
other physical damage could cause problems with string
balance and output level.
3. For optimum performance and balance, the bridge slot
must have a clean and flat bottom surface. It should be
free of overspray or debris and be a minimum of 1/8" deep
with 3/16" or more being preferred. The proper depth slot
helps avoid excessive saddle tilt and maintains better
saddle contact with the pickup. A minimum of 50% of the
total saddle height must be below the top of the slot.
4. Check the saddle-to-slot fit before you begin work.
If the saddle is too loose in the slot, it will cause excessive
saddle tilt and will usually result in poor coupling to
the pickup, low output and unbalanced string response.
It is advisable to replace the saddle if it is too loose.
5. The last 1/8" at the end of the pickup is not active. At
least 1/4" of saddle must project beyond the E strings for
the pickup to produce a balanced string response. If your
guitar has inadequate saddle slot extension beyond
the outside strings, it will be necessary to drill a small
horizontal hole at the appropriate end of the slot to extend
the inactive region of the pickup beyond the saddle.
4
|
Installation Instructions