DTD RING 12 Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DTD RING 12. DTD RING 12 18 pagina's. Buoyancy compensator

Pagina afdrukken

CARE, MAINTENANCE AND STORAGE RECOMMENDATIONS

With proper care and service, the compensator can serve you for a very long
time.
The following care and maintenance procedures should be followed:
1.
After each day of use, rinse the compensator thoroughly inside and
out with clean fresh water (do not use any aggressive solutions and/or
cleaning agents).
•
Fill the inner bladder upto approximately 1/4 with clean fresh water
through the oral inflator.
•
Fully inflate the compensator and shake it well, so that the water
covers the entire inner surface.
•
Turn the compensator upside down and drain it completely
through the oral inflator.
•
Immerse the inflator in clean fresh water or rinse the outer shell
with a hose.
•
Rinse all valves and remove any sand and dirt or crystallized salt.
2.
Inflate the compensator and allow it to dry properly before storing. DO
NOT DRY IN THE SUN. Store the compensator partially inflated,
ideally spread horizontally, out of direct sunlight and in a cool, dry and
clean place.

SERVICE CHECKS

We strongly recommend that an inspection should be performed at least once
a year by an authorized. Annual inspection consists of a complete overhaul of
the inflation mechanism, and a general air leak inspection of the bladder and
valve connections. Any damage caused by insufficient maintenance of the
compensator is excluded from the warranty.
Due to frequent use, buoyancy compensators used in diving
centers, diving equipment rentals, compensators used for
professional purposes or otherwise intensively used, must be
checked at least once every 6 months. It is necessary to check the overall
condition and main safety components of the compensator. If any of these parts
show signs of wear or deterioration in performance, they must be replaced
immediately or - if replacement is not possible - the compensator must be used.

GENERAL TECHNICAL INFORMATION

The operating pressure of the inflator is 5-12 bar.
The operating pressure of the safety valve with spring 1.4 is 0.25 bar.
Revised – February 2020
15