Attwood 66513 Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} Attwood 66513. Attwood 66513 2 pagina's. 4" and 6" flush mounted cleat
Ook voor Attwood 66513: Installatie-instructies (1 pagina's)

Pagina afdrukken

4" and 6" Flush Mounted Cleat

66510, 66511, 66512, 66513, 66514, 66516

Installation Instructions

SAVE THESE INSTRUCTIONS

Form Number 69343 Rev. G

APPLICATION

Attwood flush pull-up cleats provide easy fittings for mooring and anchoring applications.

NOTE: It is recommended that the installation of the Attwood Flush Cleats be done by a

boat builder, boat dealer, or a qualified marine mechanic.

REQUIRED FOR INSTALLATION

• Adjustable wrench

• Length of 3/8" (9.5mm) I.D. hose

• Cordless drill and bits

WARNING:

To prevent personal injury, always disconnect the power source when installing or

servicing this product. Always remove the boat from the water before using any 120V AC

power tools.

LOCATION

Select an installation location that meets the following criteria:

• Location on vessel must be able to withstand loads specified in application section.

See ABYC Reg. H-40 for details and ratings.

• Location is large enough and wide enough to accommodate the entire cleat body.

• Access to the underside of the vessel is necessary for both models in order to tighten

the fasteners.

FLUSH CLEAT TEMPLATES

Figure 1

1.429"

(3.63cm)

Figure 2

1.650"

(4.19cm)

04-04

• Sabre saw

• Screwdriver

• Marine sealant

FLUSH CLEAT INSTALLATION INSTRUCTIONS

NOTE: Before you drill or cut a hole on your boat, BE ABSOLUTELY CERTAIN there is

room for the unit beneath the deck or gunwale where it will be installed. The cleat mechanism,

in the down position, will be recessed beneath the deck or gunwale.

1. Use templates provided to mark opening in deck (Figure 1 or 2). Cut using sabre saw

and drill four 1/4" (6.4mm) holes where indicated (thru-bolt cleat only).

2. Remove the supplied fasteners from the studded cleat. Apply a small bead of marine

sealant around the edge of the cut-out and place cleat in hole cut-out.

3. Align backing plate with the underside of the cleat. For the 4" thru-bolt version use (4)

#10 machine screws, locking washers and nuts (regular washers and nylock nuts can

be substituted). For the 6" thru-bolt version use (4) 1/4"-20 machine screws, locking

washers and nuts (regular washers and nylock nuts can be substituted).

4. Ensure the screw is long enough to provide for proper engagement with the nut. Attach

washers and nuts to the studs or screws and tighten.

WARNING:

The Flush Cleats are not to be used for towing, lifting, or for any other anchoring application

beyond those listed above. Any misuse of the intended application may result in personal

injury and/or damage to the boat.

4.764" (12.1cm)

1.657" (4.21cm)

7/8" Radius

4" Cut-Out Template

6.475" (16.45cm)

2.220" (5.64cm)

1" Radius

6" Cut-Out Template

1.75"

(4.45cm)

(5.08cm)