Comtrend Corporation WAP-5940 Handleiding voor snelle installatie - Pagina 2
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Comtrend Corporation WAP-5940. Comtrend Corporation WAP-5940 2 pagina's. Wireless video bridge
Ook voor Comtrend Corporation WAP-5940: Handleiding voor snelle installatie (2 pagina's), Handleiding voor snelle installatie (2 pagina's)
Pagina afdrukken
A.
C
B.
Setup of Wireless Devices via WPS (WiFi Protected Setup)
NOTE:
If you do not wish to setup your Wireless Video Bridges via WPS please visit our User Manual for more
information.
5.
Press and release the WPS button on the device setup in AP Mode and the WPS LED will start to blink GREEN.
6.
Within two minutes press and release the WPS button on the device setup in Client Mode and the WPS LED will start to blink GREEN.
7.
Upon successful connection, the WPS LED and WiFi LED will light up solid
8.
Repeat steps 3-7 to add additional client devices.
Please refer to Section E for troubleshooting if the devices are not working properly.
Your Wireless Video Bridges are now setup! Enjoy your video streaming!
D
E
Troubleshooting
The following information should help you diagnose basic setup or installation problems.
POWER Indicator is OFF: If the Power LED goes off, please make sure that your power outlet is working properly (perhaps by testing with another
device). Then, plug in your WAP-5940 again and make sure to press the Power Button to the ON position (IN).
ETHERNET LED is OFF: If the ETHERNET LED fails to light up, check that the LAN port of the WAP-5940 unit is connected firmly to the LAN port of the
other device. To check the condition of the Ethernet cable, use another cable to test the same connection.
WPS LED is OFF: If the WPS LED(s) fails to light up, press and release the WPS Button on the device setup in AP Mode. Within two minutes press
and release the WPS Button on the device setup in Client Mode (during this time both WPS LEDs will blink). Upon successful connection the WPS
LEDs will light up solid
GREEN
AP LED is OFF: WAP-5940 in Client Mode. Set the Wireless Video Bridge to AP Mode by sliding the AP/Client Switch to the up position.
CLIENT LED is OFF: WAP-5940 in AP Mode. Set the Wireless Video Bridge to Client Mode by sliding the AP/Client Switch to the down position.
RESET: If you have tried the above and are still experiencing problems, you can reset both devices to factory default by using a pin to push in
the Reset Button for more than 5 seconds, then release the button.
FOR MORE HELP: For instructions on advanced features, FAQ, etc., please visit our product online at:
http://us.comtrend.com
For more information: YouTube Channel:
Facebook:
Support: Visit our website or call 1-877-COMTREND
(1-877-266-8736)
on both of the Wireless Video Bridges.
https://www.youtube.com/user/ComtrendConnection
https://facebook.com/Comtrend
GREEN
on both of the Wireless Video Bridges.
Page 2