Comtrol RocketLinx ES7510 Snelle installatiehandleiding - Pagina 5
Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} Comtrol RocketLinx ES7510. Comtrol RocketLinx ES7510 8 pagina's. Industrial 10-port gigabit managed poe plus switch
Pagina afdrukkenAll the Fast Ethernet ports automatically detect the signal from the connected devices to
negotiate the link speed and duplex mode. Auto MDI/MDIX allows you to connect another
switch, hub, or workstation without changing straight-through or crossover cables. Crossover
cables cross-connect the transmit lines at each end to the received lines at the opposite end.
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Straight-Through Cabling Schematic
The Ethernet cables use Pins 1, 2, 3, and 6 of an 8-pin RJ45 connector. The signals of these
pins are converted by the automatic MDIX function, as shown in the following table.
Connect one side of an Ethernet cable into any switch port and connect the other side to your
attached device. The LINK/ACT LED is lit when the cable is correctly connected. Always make
sure that the cables between the switches and attached devices (for example, switch, hub, or
workstation) are less than 100 meters (328 feet).
The wiring cable types are as follows:
1000BASE-TX: 4-pair UTP/STP Category 5 cable, EIA/TIA-568 100-ohm (100m)
IEEE 802.3af: 4-pair UTP/STP Category 5 cable, EIA/TIA-568 100-ohm (100m)
IEEE 802.3at: 4-pair UTP/STP Category 5e / 6 cable, EIA/TIA-568 100-ohm (100m)
Router or PC
3 RD+
6 RD-
1 TD+
2 TD-
Pin
MDIX Signals
1
RD+
2
RD-
3
TD+
6
TD-
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Crossover Cabling Schematic
MDI Signals
TD+
TD-
RD+
RD-
4
Switch
3 TD+
6 TD-
1 RD+
2 RD-