Comtrol RocketLinx ES8108 Gebruikershandleiding - Pagina 11
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Comtrol RocketLinx ES8108. Comtrol RocketLinx ES8108 20 pagina's. Industrial
Ook voor Comtrol RocketLinx ES8108: Snelle installatiehandleiding (6 pagina's), Snelle installatiehandleiding (8 pagina's), Snelle installatiehandleiding (8 pagina's)
Pagina afdrukken
Hardware Installation
You can use the following subsections to install the RocketLinx ES8108/ES8108F:
•
Connecting the Power and Ground
•
Wiring the Relay Output
•
Enabling the Event Alarm
•
Mounting the RocketLinx ES8108/ES8108F
•
Connecting the Ethernet Ports
•
Connecting the Fiber Port (RocketLinx ES8108F)
Connecting the Power and Ground
Use the following procedure to connect the power and the ground.
1.
Insert the positive and negative wires (12-24AWG) into V+ and V- contacts.
2.
Tighten the wire-clamp screws to prevent the wires from coming loose.
Note: Power should be disconnected from the power supply before connecting it to
the switch. Otherwise, your screwdriver blade can inadvertently short your
terminal connections to the grounded enclosure.
•
PWR1 and PWR2 support power redundancy and reverse polarity protection.
•
If both power inputs are connected, the RocketLinx ES8108/ES8108F is
powered from the highest connected voltage.
•
The RocketLinx ES8108/ES8108F will emit an alarm if the ES8108/ES8108F is no longer receiving power.
•
Positive and negative power system inputs are both accepted but PWR1 and PWR2 must apply the same mode.
3.
Connect a ground wire between the chassis and earth ground using 12-24AWG wire to ensure that the RocketLinx
ES8108/ES8108F is not damaged by noise or electrical shock.
a.
Loosen the earth ground screw (displayed in the previous illustration).
b.
Tighten the screw after the earth ground wire is connected.
Hardware Installation
on Page 12
on Page 12
on Page 13
on Page 13
on Page 14
Note: Do not connect to AC line - Neutral.
RocketLinx ES8108/ES8108F User Guide: 2000514 Rev. B - 11