ABSTRACT Gladiator Revolution Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ABSTRACT Gladiator Revolution. ABSTRACT Gladiator Revolution 19 pagina's.

Abstract Universal Instruction Manual

Setup for DMX controlled mode

When using DMX, all the units receive all the channels. You need to tell each

unit which channel to respond to (its 'base channel'). You do this by setting dip

switches 1-9 to the binary code of the channel you want. See the back page of

this manual if you need help with this, or the most common settings are printed

on the top of the unit.

Note: if you want two units to behave exactly the same, you can set

the dip switches for both units to the same channel.

You can change the dipswitches while the units are running, and the new

settings will take effect immediately. You don't need to turn the unit off and on.

Connect your controller to the DMX in socket on the first unit, using a 3-

pin XLR cable. If you are using a controller with a 5-pin DMX output, you

will need to use a 5 to 3 pin adaptor with pins 2 and 3 swapped (pin 2 is

'hot'). Connect the next unit, if you have one, to the DMX output plug.

This unit buffers the DMX signal as it passes through the unit, which means that

you can connect as many units together as you want. You don't need to connect

a line terminator in the last unit.

If you are using the Abstract CE controller, you should set up the controller to

match the heads you have connected. Refer to the controller manual for help on

this.

If the controller does not have a setting for the ClubScan or ClubRevolution, use

the Futurescan 3CED setting. If no Twister 4 setting is provided use Galactic

Moon.

If no DuoColour setting is provided use two Colour Changer heads to control

each side of the DuoColour separately. The left hand side will be at the DMX

channel you set on the dip switches. The right hand side will be two channels

further up, i.e. if you set the dip switches to channel 1, one side of the unit will

be on channel 1 and the other side is on channel 3.

Page 7