Aube Technologies TH104 Installatie-instructies en gebruikershandleiding - Pagina 2
Blader online of download pdf Installatie-instructies en gebruikershandleiding voor {categorie_naam} Aube Technologies TH104. Aube Technologies TH104 5 pagina's. Aube technologies thermostat installation instructions and owner's guide
Ook voor Aube Technologies TH104: Gebruikershandleiding (4 pagina's)
Pagina afdrukken
Push the excess wire into
the electrical box to prevent
interference with the thermostat.
Secure the base to the electrical
box using the provided screws.
The base can be secured on the
left or right hand side of the electri-
cal box.
Once the thermostat is configured and installed, return power to
heating system.
Keep the thermostat's air vents clean and free from obstructions.
To view the ambient temperature,
peel the lower-right section of the
sticker and remove it from the display.
When
you
first
power
thermostat, the display
indicates: 0:00, MO (Monday),
ambient temperature and the MANual
mode is selected (framed). The
default setpoint is preset to 20°C.
Protected memory
During a power failure, all programs are protected. The thermostat
display remains on for approximately 15 minutes after which the LP
indicator is displayed (low power). Only the time must be reset if the
power failure exceeds 6 hours. The thermostat will automatically
return to the previous mode when power returns.
The TH104 offers the following options:
Temperature display
Time display
Temperature control
Highlighted options are factory pre-set. If these options fit your
requirements, go to the next menu.
To change the temperature display from °C to °F and vice-versa:
Press and hold
, do not release.
Reset the thermostat using a pointed object (e.g. paperclip).
Release the
button.
on
the
the
°C
°F
24 h
12 h
Proportional
Conventional
To change the time display format from 12 to
24 hours and vice-versa:
Press and hold
; do not release.
Reset the thermostat using a pointed object
(e.g. paperclip).
Release the
button.
The TH104 is factory-set to use the proportional temperature con-
trol type (15-second cycles).
Since this temperature control type uses a fast commutation rate, it
is not compatible with fan-equipped systems. Also, it can also cause
light flickering, especially in rural regions.
If you have a fan-equipped system, use the conventional tempera-
ture control type (15-minute cycles). To change the type:
Press and maintain
Reset the thermostat using a pointed object (e.g. paperclip).
Release the
button.
Following the change, the FAN indicator is displayed on the screen.
To revert to proportional control, repeat above steps.
NOTE:
You should select the options before you adjust the clock
and day settings because using the reset button when selecting
options will reset the clock.
The TIME icon flashes to indicate that the
clock needs to be adjusted.
!
Press
to set the day.
"
Use the
and
set the clock.
#
Press
to exit.
The TH104 has three operating modes:
This mode automatically runs your programs.
Press MODE until AUTO is outlined. The current
program number is displayed above the AUTO icon.
To temporarily bypass the current program, simply
select the desired temperature using the tempera-
ture adjustment buttons. The new setpoint will be
maintained until the beginning of the next program.
Maintains a constant temperature setpoint.
Press MODE until MAN is outlined and select the
desired temperature using the temperature adjust-
ment buttons.
TO RESET
THE
THERMOSTAT
, do not release.
buttons to
2/4
400-104-000-A