Auber Instruments HD220 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Auber Instruments HD220. Auber Instruments HD220 5 pagina's. Dual output programmable humidity controller

Pagina afdrukken
AUBER INSTRUMENTS
11. Connect the Sensor to the Controller
The connector of sensor contains a slot for fitting pin connection. It also has a
spring lock to prevent disconnections from accidental pulling on the cable.
To install the sensor to the controller: 1) Identify the key on the male sensor
connector (Figure 5, a) and the notch on the female connector (Figure 5, b). 2)
Hold the tail of the female connector, align the notch and the key, and push the
female connector forward.
To remove the connector, hold the spring loaded collar on the female
connector and pull it back. Please see Figure 6.
Figure 5. Install the sensor.
2018.06
(a)
(b)
E-mail: [email protected] Tel: 770-569-8420
Copyright 2007-2018, Auber Instruments All Rights Reserved.
(c)
No part of this manual shall be copied, reproduced, or transmitted in any way without the
prior, written consent of Auber Instruments. Auber Instruments retains the exclusive
rights to all information included in this document.
WWW.AUBERINS.COM
Figure 6. Remove the sensor.
Auber Instruments
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022, USA
www.auberins.com
P5/5