Auber Instruments WS Series Beknopte handleiding - Pagina 8

Blader online of download pdf Beknopte handleiding voor {categorie_naam} Auber Instruments WS Series. Auber Instruments WS Series 14 pagina's. Programmable pid temperature controller with dual probe
Ook voor Auber Instruments WS Series: Beknopte handleiding (15 pagina's), Beknopte handleiding (14 pagina's), Bedienings- en instructiehandleiding (18 pagina's), Bedienings- en instructiehandleiding (18 pagina's)

3. Programming the smoking temperature profile.

A total of 6 steps can be programmed with this controller. Each step contains the set

temperature (C-X) and an ending criteria setting (E-X), where "X" is the step number (e.g.

Step 4 temperature is represented by C-4 and step 4 ending criterion is represented by

E-4). The ending criterion determines how the controller finishes the current step and

starts the next step. There are two options for the user, t and F. Set E-X to t if you want

step X to be end by a preset time. Set E-X to "F" if you want step X to end by a preset

temperature of the internal probe.

If you set E-X to "t", you will be asked to set t-X for the time. Time is defined as the

duration between the last step and the next step. Please make sure the time is long

enough for the heater to heat up the smoker. If the time is set too short, the temperature

may not be able to reach the current step temperature setting, before it jumps to the next

step. The time unit is in hours with 0.1 hour (6 minute) resolution.

If you set E-X to F, you will be asked to set F-X for the temperature of the internal probe.

If all of the E-X are set to t, the controller can operate with only the probe 1 plugged in.

To program the temperature profile, press SET key once. The display will show C-1 at

the left window and temperature setting on the right window for step 1. Use "+" and "-"

keys to change the setting. When finished, press the SET again to confirm the change.

The display will show E-1 on the left window and the ending criterion setting on the right

window. Use "+" and "-" keys to change the settings. When finished, press the SET again

to confirm the change. The left window will display t-1 or F-1 depending whether t or F is

selected for the E-1. The right window will display the setting for t-1 or F-1. Use "+" and "-"

keys to change the setting. When finished, press the SET again to confirm the change.

The display will go the step 2 setting. It will repeat in the same way as the step 1. After

you program enough steps for your recipe, you can program the rest of the steps of E-X

to t and set t-X to zero.

The temperature setting will not be changed if SET is not pressed (confirmed). After

programming the necessary steps for cooking, you can finish programming by pressing

the SET continuously until it passed T-6 and display the current temperature. You can

also leave the controller alone. The display will return to the normal display mode if no

key is pressed within 15 seconds.

The initial program setting for the controller is listed in

Table 1. This program will control the temperature of the cabinet at 120 ° F for 2 hours.

Then, change the temperature to 190 ° F. It will stay at 190 ° F until internal temperature of

the meat reaches 160 ° F. Then, the controller will drop the temperature to 130 ° F for 30