Auburn Gear Power Wheel Model 5 Servicehandleiding - Pagina 3

Blader online of download pdf Servicehandleiding voor {categorie_naam} Auburn Gear Power Wheel Model 5. Auburn Gear Power Wheel Model 5 4 pagina's. Single reduction shaft and spindle output drives

Pagina afdrukken

STEP 8

Place sun gear (13) into carrier assembly (12). Sun gear

(13) should turn freely by hand.

STEP 9

Apply a bead of silicone sealant to cover face of ring gear

(11). See instructions on sealant package.

STEP 10

Secure thrust washer (14) with tangs engaged in cover

(15). N

: Washer (14) can be secured to cover (15)

OTE

with a small amount of grease or silicone sealant. Install

the cover (15) and align with hub (6) such that pipe plug

holes on cover (15) align with mounting holes on hub (6).

NOTE: When installing a hydraulic motor to the Power Wheel drive it is necessary to place an "O" ring or gasket (not supplied by

Auburn Gear) between the motor and the planetary drive. "O" ring sizes: SAE A 2-042, SAE B 2-155, SAE C 2-159, SAE D 2-

163. Apply sealant to motor mounting bolt threads when holes in cover are thru holes.

It is recommended that the carrier assembly (12) be serviced in its entirety to protect the integrity of the Power Wheel drive.

IMPORTANT: POWER WHEEL PLANETARY DRIVES ARE SHIPPED WITHOUT LUBRICANT AND MUST BE FILLED TO

THE PROPER LEVEL PRIOR TO START UP.

Observe lubrication recommendations given by the original equipment manufacturer. When specific recommendations are not

available, use mild extreme pressure lubricant API-GL-5, No. 80 or 90 when filling the Power Wheel under normal temperature

ranges between 0 - 120°F (-18 to 49°C). Power Wheel is to be half full of oil when unit is mounted level and horizontal. Use drain

and fill plugs located in cover. Oil is to be changed after first 50 hours of operation with subsequent changes every 1000 hours or

yearly, which ever comes first. If unit is to be operated vertically, if ambient conditions are outside the specified range, or if the oil

temperature exceeds 200°F (93°C) contact Auburn Gear for oil and level recommendations.

A protective film is applied to the Power Wheel at the factory to prevent rust during shipment. Additional protection may be

required if the Power Wheel is to be stored for an extended period of time.

Silastic RTV732 sealer and General Electric Silimate RTV No. 1473 or RTV No. 1503 are recommended for sealing gasket

surfaces. Sealant should be applied in a continuous bead, which should be centered on the surface to be sealed but should move

to the inside of the hole at each bolt hole location. For service requirements order Auburn Gear part number 604101.

Maximum intermittent output torque .................................................................................................. 60,000 lb. in. (6,780 Nm)

Maximum input speed ......................................................................................................................................... 5,000 RPM

Oil capacity ................................................................................................................................................. 38 oz (1,125 ml)

CARRIER ASSEMBLIES

LUBRICATION RECOMMENDATIONS

STORAGE

SEALING COMPOUND

SPECIFICATIONS

STEP 11

Install twelve washers (17) and Grade 8 bolts (18) and

torque to 40 - 45 lb. ft. (54 - 61 Nm) with dry threads.

Lubed threads torque to 20 - 25 lb. ft. (27 - 34 Nm).

STEP 12

Position filler opening horizontally and fill unit to oil level

hole in cover (15). Install pipe plugs (16 & 19) in cover

(15) and pipe plug (5) in hub (6).