daltile 1048BRS Bedieningshandleiding - Pagina 14
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} daltile 1048BRS. daltile 1048BRS 20 pagina's. Professional tile saw
Pagina afdrukkenOPERATING INSTRUCTIONS
Single Step Cutting
DO NOT FORCE THE TOOL! It will do the
job better and safer at the rate for which it
was designed.
Use original DALTOOL ® wet cutting blades
only.
Loosen the Adjustable Cutting Guide
●
retaining knob.
Retaining Knob
Position the Adjustable Cutting Guide to
●
desired cutting length.
Tighten the retaining knob.
●
Place the tile against the Ruler/Stop
and Cutting Guide.
Turn the motor ON.
●
Verify proper coolant flow on both sides
●
of the blade.
Perform the cut.
●
Turn the motor OFF when work is
●
complete.
Multiple Step Cutting
During this sawing process the saw is posi-
tioned at the desired height and moved back
and forth through the material to be cut until
after a number of steps it is completely cut
through.
Place the material to be cut on the
●
sawing table and position against the
fixed stop and eventually the adjustable
stop.
PAGE 14 DALTOOL 1048BrS OPERATING MANUAL V02/2008R1
Cutting Guide
Position the cutting head at the desired
●
height
Hold the material with one hand while
●
making sure your hand is free from the
cutting blade.
Perform the cut. This process must be
●
repeated until the material has been
totally cut through.
Turn the motor OFF when work is
●
complete.
45˚ Miter Cutting:
The DALTOOL® 1048BrS Tile Saw is desig-
ned to perform 45˚ Miter Cuts without addi-
tional tools.
Loosen the 2 handles on either side of
●
the machine.
Tilt the cutting head into the 45˚ position.
●
Fasten both handles.
●
Place the tile on the cutting table in the
●
desired position.
Hold the tile down with one hand. (Keep
●
hand away as far as possible from the
cutting blade)
Turn the motor ON.
●
Verify proper coolant flow on both sides
●
of the blade.
Perform the cut.
●
Turn the motor OFF when work is
●
complete.