daltile 1048BRS Bedieningshandleiding - Pagina 9

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} daltile 1048BRS. daltile 1048BRS 20 pagina's. Professional tile saw

Pagina afdrukken

ELECTRICAL REQUIREMENTS

AND GROUNDING

INSTRUCTIONS.

In order to prevent potential electrical shock

and injury, the following electrical safety

precautions and symbols should be followed

at all times!

In case of a malfunction or break-

down, grounding provides a path of

least resistance for electric current

to reduce the risk of electric shock.

This tool is equipped with an electric cord

having an equipment-grounding conductor

and a grounding plug. The plug must be

plugged into a matching outlet that is pro-

perly installed and grounded in accordance

with all local codes and ordinances.

Do not modify the plug provided – if it

●

will not fit the outlet; have the proper

outlet installed by a qualified electrician.

Improper connections of the equipment

●

grounding conductor can result in a risk

of electric shock. The equipment-

groun ding conductor is the insulated

conductor that has an outer surface that

is green with or without yellow stripes. If

repair or replacement of the electric

cord or plug is necessary, do not

connect the equipment-grounding con-

ductor to a live terminal.

Check with a qualified electrician or

●

service personnel if the grounding

instructions are not completely under-

stood, or if in doubt s to whether the tool

is properly grounded.

Use only 3-wire extension cords that

●

have 3-prong grounding plugs and

3-pole receptacles that accept the tool's

plug.

Repair or replace a damaged or worn

●

cord immediately.

DALTOOL

SAFETY

This tool is intended for use on a

circuit that has a 3 pole outlet.

To reduce the risk of electrocuta-

tion, keep all connections dry and

off the ground.

A Ground Fault Circuit Interrupter (GFCI)

should be provided on the circuit(s) or

outlet(s)to be used for the Saw. Receptacles

are available having built-in GFCI protections

and may be used for this measure of safety. A

GFCI is not supplied with the machine.

When using an extension cord, the GFCI

should be installed closest to the power

source, followed by the extension cord and

lastly, the saw.

Shock Hazard. For replacement, use only

an identical DALTOOL water pump, Item #

6.513.298

To avoid the possibility of the machi-

nes plug or electrical outlet getting

wet, position the saw to one side

of a wall mounted outlet. This will

prevent water from dripping onto the outlet

or plug. A "drip loop" should be arranged by

the user to properly position the power cord

relative to the power source. The "drip loop"

is that part of the cord below the level of the

outlet, or the connector, if an extension cord

is used.

Continued on page 10

DALTOOL 1048BrS OPERATING MANUAL V02/2008R1 PAGE 9