Conair 20 PIECE HC409WC Instructies voor onderhoud en gebruik - Pagina 4
Blader online of download pdf Instructies voor onderhoud en gebruik voor {categorie_naam} Conair 20 PIECE HC409WC. Conair 20 PIECE HC409WC 8 pagina's. Haircut kit
Pagina afdrukken
must cover or be to the extreme left hand of the
first small tooth of the cutter.
*Be sure that the extreme right hand big tooth of
the cutter touches the extreme right hand tooth
of the cutting comb.
SPECIAL OIL
To maintain the blades of your Conair
clipper, oil them after every three or four hair-
cuts. Gently place a few drops of oil on the teeth
of the blades, using the special Conair
cluded with your set. Turn the clipper on for a
minute, then turn off. This light, natural oil was
formulated specifically for the Conair
speed clipper. Because it is the right oil to use,
it will not slow down the blades. Never use any
other product. There is no substitute for Conair
oil.
ADJUSTABLE TAPER LEVER
Just like professional clippers, the Conair taper
lever is positioned at your thumb. You can hold
the clipper in your hand and adjust the lever at
the same time...while you're clipping.
This taper lever eliminates the need for an
attachment comb because it lets you gradually
adjust the closeness of the cut. For the closest
cut and the shortest hair, push taper lever up as
far as it will go. To increase cutting length, slowly
push lever down. If you push to the lowest posi-
tion, it will leave hair about the same length as
the short attachment.
Because a different cutting edge is used in each
setting, the taper lever lengthens the life of your
blades.
Packed-in hair can slow down any clipper. To
remove it, without removing the blades, take
your cleaning brush and brush the hair from the
blades. If you do this after every clipping, espe-
cially with heavy hair cutting, the blades should
remain free of cut hair. If clipper stops cutting
and this action doesn't help, you might have to
loosen the blades to remove the hair.
®
CAUTION: Never pull on the clipper cord.
Never twist or wrap the cord around the
clipper. Lay it flat with the cord coiled up when
oil in-
®
not in use.
For new blades, send check or money
order for $8.00 (which includes postage
high-
®
and handling) to:
Conair Consumer Products Inc.
100 Conair Parkway,
Woodbridge, Ont. L4H OL2